Wirata HD-668 User manual

MODEL NO.
HD-668
HD-668A
POWER
2000W
2000W
VOLTAGE
220-240V
220-240V
FREQUENCY
50/60Hz
50/60Hz
INSTRUCTION MANUAL
Model No.:
HD-668, HD-668A
Please read Instruction Manual before use
& follow ALL the instructions carefully.

WHAT’S IN THE BOX
1. Hair Dryer –1set
PARTS DESCRIPTION
1: Adjustable concentrator 4: Temperature button
2: Cool shot button 5: Hanging loop
3: Speed button 6: Air inlet
MAIN COMPONENT：
(Product may vary slightly from what is illustrated)
1
2
3
4
5
6

This product is designed and manufactured with high
standards. It has the excellent characteristics of well-
structure, smooth lines, fashion style, convenience, safety
and dependence.
Please read this instruction carefully. Please put it in a
suitable place. If you want to transfer it to others, please
give them the instruction together.
This appliance only uses 220-240V.
The instructions for portable electrical appliance shall include
the substance of the followings:
When the electrical appliance is used in a bathroom, unplug it
after use since the proximity of water presents a hazard even
when the electrical appliance is switched off, for additional
protection, the installation of a residual current device (RCD)
having a rated residual operating current not exceeding 30mA
is advisable in the electrical circuit supplying the bathroom. Ask
your installer for advice.
The electrical appliance is not intended for used by person
(including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the
appliance.
GENERAL INSTRUCTION
SAFETY INSTRUCTIONS
WARNING: Do not use the device near water, over the bath tub,
pool or other water basin.
*Observe the above-mentioned rules in order to avoid burning,
electric shock or fire hazard. Make sure you understand the
instructions.

1. Press the switch up to I (soft wind), press the temperature
button, the temperature will be higher and higher. Press
the button of cool wind, then it is switched to (cool wind).
2. Press the switch down to II (strong wind), press
temperature button, the temperature will be higher and
higher. Press the button of cold wind, then it is switched to
(cool wind).
3. Press the switch to 0 (off).
4. This product has an overload protecting set (if the air inlet
or outlet opening is obstructed), which can automatically
cut off the power. When you meet such situation, you’d
better press the switch to 0, after a few minutes you can
open and use it again.
5. There is a wind-gathering mouth for you to gather the wind
to speed up drying and finalizing the design.
Our factory is responsible for any unqualified products or parts,
but if the damage which caused by incorrect operation, our
factory will not take any responsibility; if the product needs
reparation, send it to the local dealers with the related notes.
HOW TO OPERATE
REPARATION CARD