Wisco Industries 695D User manual

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 1 of 4
*For instruconal purposes, model 695D is shown in photos. However, instrucons for the 925 series are the same.*

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 2 of 4
Remove side panel by pushing the graphic panel in gently
to separate the latches. Then pull the panel up and out.
Remove (8) screws and remove the top.

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 3 of 4
Remove (4) screws on top of the
Air Lid Assembly and remove the
assembly.
Disconect motor wires (marked
by yellow arrows below) Remove (1) screw holding the
blower motor bracket in place
and remove the blower motor
assembly.

Models 695D/925 Series-
Blower Motor Replacement
0022309
FS140138 REV: ORIG
7-31-2020 Page 4 of 4
Remove (8) Screws from the motor’s bracket and disassemble the bracket.
Using the new motor, complete all steps in reverse order and you have successfully replaced your units blower motor. Your
unit is now ready for operaon.