BATTERY USAGE (Optional)
If powered by batteries, insert the batteries according to following steps.
1. Unscrew and remove the battery compartment cover on the top of
bubble machine.
2. Insert 6 x 1.5V C Cell Batteries (Not Included) into the battery
compartment on correct polarity to eliminate fire danger.
3. Cover the battery compartment.
WARNING: When powered by batteries, remove power adapter from
bubble machine or it won't work.
ATTENTION: It is normal for bubble machine to produce less bubbles
when using battery power than when plugged in with a power adapter.
GENERAL INSTRUCTIONS
●
Keep the air intake ports free from blockage.
●
Do not use outdoors in the rain as this may lead to a short circuit.
●
Do not leave unused liquid in the reservoir for an extended period. The
liquid may thicken in the reservoir. Remove all liquid before storing or
moving.
●
If the bubble machine is to be mounted using a bracket, please note
the machine should only be inclined to a maximum angle of 15 degrees.
●
The bubble machine should not be used for more than 8 hours
consecutively and is best operated at 40º-90ºF (4º-32ºC). Performance
of the machine may be reduced in low temperatures.
- 3 -
CAUTION:
There's liquid residue to build upin the front ground
of the of the machine. This can cause a slick area and
create a slipping hazard.
CLEANING INSTRUCTIONS
1. Empty the residual bubble liquid in liquid reservoir.
2. Rinse and drain the liquid reservoir using a little distilled water.
3. Add some warm distilled water to the maximum level.
4. Turn on and allow it to run in a well-ventilated area until all wands
appear to be free of residue.
5. Drain the remaining water to complete cleaning.
6. Surface clean only with a soft, dry cloth. Unplug unit before cleaning.
