MAINTENANCE & CLEANING
1. Unplug the A/C power cord before maintenance and cleaning.
2. Empty the residual fog liquid and bubble liquid from their liquid
drainage outlet.
3. Pour 300ml distilled water into each liquid tank, and let this machine
work for 5 to 10 minutes.
4. Surface clean only with a soft, dry cloth.
CAUTIONS & WARNINGS
●
This product is recommended for indoor use only. To reduce the risk
of fire or shock hazard, do not expose this product to rain, moisture or
dust.
●
Hot surface. Avoid contact, always use the handle to carry the fog
bubble machine.
●
Replace fuse only with 5.0 Amps, 125 Volts fuse.
●
For adult use only. Keep out of reach of children and pets. When
children or pets are present, close adult supervision is necessary.
●
Always operate the unit in an open, well-ventilated area.
●
Do not leave unattended while in use. Always unplug the unit from
the electrical outlet when unattended.
●
Use with a 3 prong, grounded electrical outlet only.
●
Do not operate within 3 feet of electrical devices, such as refrigerators,
televisions, microwaves or heaters.
- 3 -
CAUTION:
There's liquid residue to build upin the front ground
of the of the machine. This can cause a slick area and
create a slipping hazard.
- 2 -
(10)
(11)
(13)
(12)
(14)
(9)
(9) Bubble Liquid Drainage Outlet
(10) Fog Liquid Tank
(11) Fog Liquid Level Mark
(12) Fuse
(13) Fog Liquid Drainage Outlet
(14) Power Switch
HOW TO USE
ATTENTION: Before using this machine, you should prepare the
specialized Fog Fluid and Bubble Fluid separately.
Once prepared, operation according to the following steps.
1. Place the unit onto a clean, flat and solid surface, close to a standard
A/C grounded wall outlet.
2. Unscrew the lid of fog liquid tank at the back of machine, and pour
fog fluid into the tank, then tighten the lid of tank.
3. Pour bubble fluid into the bubble liquid tank at the front of machine,
check and ensure the tube can suck up bubble liquid in the tank.
WARNNING: Fog Fluid must be pour into FOG LIQUID TANK, and
Bubble Fluid must be pour into BUBBLE LIQUID TANK. DON’T
OVERFILL AND MAKE IT THE OTHER WAY AROUND!
4. Plug the A/C power cord into the A/C grounded wall outlet.
5. Turn on Power Switch at the back of machine, a Red light will light
up indicating the unit is ON.
6. Warm up time is approximately 2 to 4 minutes. When fully heated,
the Blue light at the front of unit will light up indicating that the
machine is ready.
7. Turn on Function Switch on top of unit, the machine will be in working.
8. Keep the switch OFF before refilling your fog / bubble fluid into their
tank of unit.
9. When not in use, unplug the A/C power cord from the A/C grounded
wall outlet.
ATTENTION: When the Red light at the front of unit light up, pour
more fog fluid into fog liquid tank.
