10
WOLFEN INSTALLATION MANUAL | Installation Instructions
MIXER BODY INSTALLATION FOR ALL UNITS
Important Note
The mixer must be installed in accordance with the requirements
of the NCC Vol3 and AS/NZS3500 by a suitably qualied
licensed plumber. This product comes factory assembled
and tested for optimum service life and performance. Water
supply lines must be thoroughly ushed before connecting the
assembly. Isolating stop cocks should be installed at the heated
and cold water connection points for ease of servicing.
1. Place the base "O"-ring (33) on the underside of the
mixer body (15).
2. Screw in the hot and cold exible connectors (37) to the
mixer body (15).
3. Place the mixer unit over the prepunched tap hole
(35mm) in the counter top. Feed the exible connectors
(37) through rst.
Note: The unit must be installed with the main mixer
handle to the right side
IMPORTANT INFORMATION FOR ALL UNITS
•See the detailed wall support installation on page 11.
•See the detailed spring and trigger spray installation
on page 16
•Misuse of the product is not covered by warranty.
•Water pressure exceeding 450kPa may aect the
operational life of the product.
Note: For optimum operational life, water supply pressure
should not exceed 450kPa.
INSTALLATION INSTRUCTIONS
4. From underneath the counter top, slide on the
U-shaped washer then the U-shaped xing plate. (34 &
35)
5. Screw on the hex nuts (36) until the mixer base is rmly
xed to the sink. Tighten with a socket set or tube
spanner.
6. Connect the hot and cold exible connectors to the
inlet isolation valves.
WOLFEN INSTALLATION MANUAL | Wolfen Pre Rinse Sink Mixer
