Wooden Camera Director's Monitor Cage User manual

(2) OFFSET
BRACKET
(2)
POST
Included:
(12) 1/4-20 x 1/2" button head screws
(6) 1/4-20 x 3/8" button head screws
(2) 1/4-20 x 2" socket cap screws
(4) M3 x 8mm philips screws
(for V-Mount plate)
(4) M3 x 12mm philips screws
(for Gold Mount plate)
(1) M2.5 x 4mm socket cap screw
(for Odyssey 7Q location pin)
DIRECTOR’S MONITOR CAGE
© Wooden Camera, Inc. 2011-2014
1. Select the two MAIN BRACKETS and locate the correct
1/4-20 HOLES
2. Select the four SIDE BRACKETS, align to 1/4-20 HOLES
as shown below, select 1/4-20x1/2” SCREWS, tigthen
to MAIN BRACKET with allen wrench
3. Select the two HANDLES, locate and align the 1/4-20
HOLES to SIDE BRACKETS as shown below, select and
tighten 1/4-20x1/2” SCREWS with allen wrench
4. Select the two OFFSET BRACKETS and locate the
correct 1/4-20 HOLES on the MAIN BRACKETS
5. Locate and align SCREW CHANNELS on OFFESET
BRACKET to 1/4-20 HOLES, select and tighten
1/4-20x1/2” SCREWS with allen wrench
6. Select BATTERY PLATE, the two POSTS, and 1/4-20x2”
SCREWS
7. Locate and align the POSTS to the correct 1/4-20
HOLES on MAIN BRACKET as shown below
8. Align SCREW CHANNELS of BATTERY PLATE over
POSTS, insert and tighten 1/4-20x2” SCREWS to
MAIN BRACKET with allen wrench
(4) SIDE
BRACKET
(2)
HANDLE
(2) MAIN
BRACKET
(1)
PLATE
SCREW CHANNEL
SCREW CHANNELS

STRAIGHT BARS TOP AND BOTTOM
CONFIGURATION FOR ODYSSEY 7Q
M2.5 LOCATING PIN
1/4-20 SCREW
NOTE THE ORIENTATION VERTICAL AND HORIZONTAL