Workrite Ergonomics CONF-BSE-WP-S Programming manual

1 of 2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Phillips head screwdriver, 2.5 mm Allen Wrench, 5 mm
Allen Wrench, Drill, Drill Bit, Fasteners (not included).
Conform Monitor Arm
AWall Plate Assembly Qty: 1
Parts Included Parts Included, Hardware kit
Tools Required
Assembly & Installation Instructions:
Conform Base, Wall Plate
CONF-BSE-WP-S
Attach the Wall Plate Base to the wall
Remove Bolt & Washers.
Fasten Wall Plate Base with ¼/6 mm diameter bolts or screws
appropriate to the construction of the wall.
Required Parts Sold Separately
B5 mm Allen Wrench Qty: 1 EStatic Arm Spacer Qty: 1
FSticker Qty: 1C4 mm Allen Wrench Qty: 1
D2.5 mm Allen Wrench Qty: 1
Do not exceed 48 lb.
Mounting Surface requirement. Do not mount to drywall only!
(drywall/stud mount)
•Drywall: ⁄” sheetrock with screws
into stud backing, using 2 centered
holes.
•Use ¼”/6 mm diameter fasteners.
• Concrete: Use appropriate concrete anchors using
4 outer holes.
• Wood/steel/other solid surface: bolt or screw using
4 outer holes.
•Use ¼”/6 mm diameter fasteners.
(all other surfaces)
1
b
bb
a
a
All manuals and user guides at all-guides.com
all-guides.com

2 of 2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Insert Spacer and Bolt
Choose the appropriate spacer and re-assemble pin with
selected spacer.
Ready for Arm Installation
You are now ready to attach your selected Conform Monitor Arm (sold separately). Follow Arm installation
instructions.
Articulating Arm
Shown
1500254 Rev A
F
2
E
Static Arm
Spacer.
Articulating Arm
Spacer
3
D
Aer M8 x 90 mm bolt has been
installed and set screw has been
tightened with 2.5 mm Allen
Wrench (D), apply the sticker (F) to
cover the set screw.
Note:
All manuals and user guides at all-guides.com