Worldlawn WS2690BSE User manual

R
WS2690BSE
Safety
Setup Instructions
Product Overview
Controls
Operation
Maintenance
Storage
Troubleshooting
Snow thrower
Operator's Manual
Worldlawn Power Equipment, Inc.
Industrial Park 2415 Ashland Ave. Beatrice NE 68310
Toll Free Number: 1-800-267-4255

INTRODUCTION
This manual contains assembly, operating, maintenance, adjustment, and safety instructions for your
WS2690BSE snow throwers.
Before operating your snow thrower, read this manual in its entirety carefully.
If this manual is lost, damaged or illegible, replace it with a new one through our company's sales department,
from a dealer or download from our web site: www.worldlawnpowerequip.com.
For more information, contact our sales department or dealer. Please also indicate the model and serial
numbers of your product.
For your convenience write your equipment model and serial number below.
Model No:___________________________
Serial No: ___________________________

Table of Contents
Table of Contents
1. Safety……………………………………………………………………………………
1
1.1 Before Operating ………………………………………………………………………………
1
1.2 Training…………………………………………………………………………………………
1
1.3 Preparation………………………………………………………………………………………
1
1.4 Operation ………………………………………………………………………………………
2
1.5 Unclogging the Discharge Chute and Auger/Impeller Housing…………………………………
2
1.6 Maintenance and Storage ………………………………………………………………………
2
1.7 Snow thrower Safety ……………………………………………………………………………
3
1.8 Safety and Instructional Decals…………………………………………………………………
decal ……………………………………………………………………………………
3
2. Setup Instructions ……………………………………………………………………
5
2.1 Wheel Drive Cable Installation …………………………………………………………………
5
2.2 Auger/Impeller Cable Installation ………………………………………………………………
5
2.3 Lower Handle Installation………………………………………………………………………
5
2.4 Upper Handle Installation ………………………………………………………………………
6
2.5 Speed Control Rod Installation …………………………………………………………………
6
2.6 Discharge Chute Assembly Installation…………………………………………………………
6
2.7 Snow Clean-out Tool Installation ………………………………………………………………
7
2.8 Fill the Engine with Oil ………………………………………………………………………
7
2.9 Check the Tire Pressure ………………………………………………………………………
7
2.10 Check the Skids and Scraper …………………………………………………………………
7
3.Product Overview ………………………………………………………………………
8
4.Controls …………………………………………………………………………………
9
4.1 Auger/Impeller Drive Control Lever……………………………………………………………
9
4.2 Traction Control Lever …………………………………………………………………………
9
4.3 Speed Control Handle……………………………………………………………………………
9
4.4 RH Handle Lock Control ……………………………………………………………………
9
4.5 Discharge Chute Control Handle ………………………………………………………………
9
4.6 Deflector Control Lever…………………………………………………………………………
9
4.7 Fuel Shutoff Valve………………………………………………………………………………
9
4.8 Ignition Switch …………………………………………………………………………………
9
4.9 Choke……………………………………………………………………………………………
9
4.10 Throttle Lever …………………………………………………………………………………
9

Table of Contents
4.11 Primer …………………………………………………………………………………………
9
4.12 Electric Starter…………………………………………………………………………………
9
4.13 Recoil Starter …………………………………………………………………………………
9
4.14 Snow Clean-out Tool …………………………………………………………………………
9
5. Operation…………………………………………………………………………………
10
5.1 “Freewheeling”or Using the Self-propel Drive ………………………………………………
10
5.2 Filling the Fuel Tank……………………………………………………………………………
10
5.3 Starting the Engine………………………………………………………………………………
10
5.4 Stopping the Engine …………………………………………………………………………
11
5.5 Preventing Freeze-up …………………………………………………………………………
11
5.6 Operating Tips ………………………………………………………………………………
11
6. Maintenance……………………………………………………………………………
12
6.1 Recommended Maintenance Schedule(s)………………………………………………………
12
6.2 Preparing for Maintenance ……………………………………………………………………
13
6.3 Checking the Engine Oil Level…………………………………………………………………
13
6.4 Adjusting the Skids and Scraper…………………………………………………………………
13
6.5 Adjusting the Speed Control Handle……………………………………………………………
13
6.6 Checking the Auger Gearbox Grease……………………………………………………………
14
6.7 Changing the Engine Oil…………………………………………………………………………
14
6.8 Lubricating the Snow Thrower …………………………………………………………………
14
6.9 Inspecting and Replacing the Spark Plug………………………………………………………
15
6.10Adjusting the Traction Drive Belt ……………………………………………………………
15
6.11 Replacing the Traction Drive Belt ……………………………………………………………
15
6.12Adjusting theAuger/Impeller Drive Belt………………………………………………………
16
6.13 Replacing the Auger/Impeller Drive Belt ……………………………………………………
16
6.14 Replacing the Safety Pin………………………………………………………………………
16
6.15 Emptying the Fuel Tank………………………………………………………………………
17
7. Storage …………………………………………………………………………………
18
7.1 Preparing the Snow thrower for Storage………………………………………………………
18
7.2 Removing the Snow thrower from Storage ……………………………………………………
18
8. Troubleshooting ………………………………………………………………………
19
Limited Warranty ……………………………………………………………………
21