Xicom XTRS-100K Specification sheet

XTRS-100K
Operation and
Installation Manual
This is a controlled document.
The official version of this document is located
in Xicom Technology Document Control.
Printed copies are for reference only.
3550 Bassett Street
Santa Clara, CA 95054 USA
408-213-3000 Phone • 408-213-3001 Fax
www.xicomtech.com
Document Number: MN5-0298-001
Revision: B
Applicable to: 305-0298-001

Document Number:
MN5-0298-001
Date: May 2004
Revision: B
XTRS-100K
Operation and Installation Manual

XTRS-100K
Operation and
Installation Manual
This is a controlled document.
The official version of this document is located
in Xicom Technology Document Control.
Printed copies are for reference only.
3550 Bassett Street
Santa Clara, CA 95054 USA
408-213-3000 Phone • 408-213-3001 Fax
www.xicomtech.com
Document Number: MN5-0298-001
Revision: B
Applicable to: 305-0298-001

MN5-0298-001 ii Revision B
NOTICE
Copyright 2001, 2002, 2003, 2004
This document contains proprietary information that is protected by copyright. All rights
are reserved.
The information in this document is subject to change without notice. Please contact
Xicom Technology for current technical specifications.
Xicom Technology reserves the right to revise this publication and to make changes
from time to time in the content hereof without obligation of Xicom Technology to notify
any person of such revision or changes.
Xicom Technology makes no warranty of any kind with regard to this material, including,
but not limited to, the implied warranties of fitness for a particular purpose. Xicom
Technology shall not be liable for errors contained herein or for incidental consequential
damages in connection with the furnishing, performance, or use of this material.

MN5-0298-001 iii Revision B
XTRS-100K Operation and Installation Manual
About this manual
This manual provides operators and technicians with a set of
tools for operating and maintaining the Outdoor Unit Family of
Xicom Solid State Power Amplifiers.
This Prefix contains a Table of Contents that applies to the
entire manual and a Record of Changes page that applies only
to this Prefix.
Each Chapter has its own Part Number, Revision Level, Record
of Changes page, Table of Contents, List of Figures, and List of
Tables.
Chapter One — Provides an overview of the manual; delineates
who should use the manual; how to contact Xicom Technology.
Chapter Two — Describes safety information that pertains to
Xicom Technology products. It also provides information about
Warnings, Cautions and Notes that are found throughout the
manual.
Chapter Three — Provides general installation information,
communication interface switch settings and cable pinouts.
Chapter Four — Provides the operating instructions for the
power amplifier.
Chapter Five — Provides communication protocols used with
Xicom Technology Solid State Amplifiers.
Chapter Six — Provides the information necessary to update the
amplifier firmware.
Chapter Seven — Describes the preventive maintenance
requirements for Xicom Technology power amplifiers.
Chapter Eight — Provides information regarding service and
repair of Xicom Technology power amplifiers, including
instructions on obtaining RMA (Return Maintenance
Authorization) Numbers.
List of Abbreviations, Acronyms, and CE Symbols—Lists the
abbreviations, acronyms, and CE symbols that may be found in
Xicom Technology documentation.
Appendices — The Appendices provide operators and
technicians with information and specifications that are specific
to their particular version of Xicom Technology Power Amplifier.

MN5-0298-001 iv Revision B
XTRS-100K Operation and Installation Manual
Who should use this manual
This manual is designed for use by trained operators and
technicians who have a thorough knowledge of satellite
transmitting and receiving equipment.
Persons using this manual should familiarize themselves with
the information in the Appendices before reading the main
sections.

MN5-0298-001 v Revision B
XTRS-100K Operation and Installation Manual
Record of Changes
Revision ECO Description Date Initiated By
1 Preliminary Release 06/02/2003 A.L. Crozier, Jr.
A 11266 Original Release 07/18/2003 A.L. Crozier, Jr.
B 12136 Update Table of Contents 05/13/2004 A.L. Crozier, Jr.

MN5-0298-001 vi Revision B
XTRS-100K Operation and Installation Manual
Table of Contents
Paragraph Title Page Number
List of Abbreviations, Acronyms, and CE Symbols MNC-0000-010
Chapter 1 Overview, Rack Solid State Amplifier MNC-0100-018
Chapter 2 Safety MNC-0200-006
Chapter 3 Unpacking and Installation,
Rack Solid State Amplifiers MNC-0300-021
Chapter 4 Operation MNC-0400-020
Chapter 5 Amplifier Communication and Protocol MNC-0500-009
Chapter 6 Firmware Update Procedure, SSPA MNC-0500-014
Preventive Maintenance MNC-0600-009
Chapter 7 Service and Repair MNC-0700-001
Appendix A Product Specifications 305-0298-001
Appendix B Mechanical Drawings
SSPA Outline 304-0256-001
SSPA DC Power Supply Outline 304-0243-001
Appendix C Interconnect Drawings
RF Unit Interconnect 307-0742-001
Logic Interconnect 307-0743-001
Power Supply Unit Interconnect 307-0683-001
Appendix D Power Supply Removal, Rack Solid State Amplifier MNC-0000-014
Appendix E Operation Addendum, SSPA W/G Switch Control
Termination Cable MNC-0000-022