XL displays Star Tent User manual

PARTS
(NOT TO SCALE)
TOOLS REQUIRED
FOR ATTENTION
IMPORTANT NOTE:
PAY ATTENTION TO WIND
DIRECTION WHEN
ASSEMBLING/DISASSEMBLING
Ground Stakes (x6)
Wire rope setting-out guide (x1)
Ground Stake Puller (x1)
Base Support and Ground Spike (x1)
Poles (x5)
Star Tent
Assembly Instructions
Ensuring the ground the tent is to be pitched on is soft – use the base pole support to
mark out where the centre of the tent will be.
Slide the looped section of the wire setting rope underneath the central stake of the base
pole support and temporarily secure it into the ground
Extend the wire setting rope to full length and separate the two sections of the rope. Use the
first section of rope to mark out your first point and take the second section of the wire
setting rope and measure 4.9m across from your first point to find the second point of the tent.
www.xldisplays.co.uk
01733 511030

NOTE: Leave 2 inches of theground stake
above the ground
NOTE: Remove groundstake from rope
before hammering
Use a mallet to secure one of the ultra-strong ground stakes into the turf where your two points are marked out, taking care to leave
two inches of the stake visible above the ground. Make sure the wire setting rope is loose and is not trapped under or attached to the
ground stakes. Repeat steps three and four until you have six points.
When you’re done, pull the central base pole support out of the ground and remove the wire setting rope from underneath.
Then, use a mallet to properly secure the base pole support into the ground.
Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030

Lay out the canopy of the tent and slot three of the metal horseshoe ends of the graphic around the ground stakes, ensuring the
centre of the graphic is draped over the central base support and three of the graphic legs are still free.
Next, slot the numbered sections of the central pole support together and slide the pole horizontally underneath the graphic, making
sure the end of the pole (part five) is level with the centre of the canopy.
X
3
SlOT IN
NOTE: The end of pole 5 fits into the top of the canopy
5
4
3
2
1
Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030

Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030
Begin to move the pole into a vertical position until it is straight and the bottom of the pole (part one) can be firmly slotted into the
central pole support base.
At this stage you can attach the remaining two horseshoe sections of the canopy to the last two ground stakes.

TURN
Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030
To tension the graphic, turn the crank on the central pole support and, once complete, remove the crank handle.

DISASSEMBLY
TURN
Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030

DISASSEMBLY
Star Tent
Assembly Instructions
www.xldisplays.co.uk
01733 511030