1 2 3
4 5
Product Overview
Turning On | Off
Connecting
Multi-pairing
Charging
Hands Free
Hands Free Specifications
Microphone
Volume+/Previous song Volume-/Next song
USB charging port
Mul-Funcon Buons
Indicator light
Press and hold MFB for 4 seconds unl
blue LED flashes
1) Keep your Bluetooth device within 1 meter when
pairing;
2) Make RQ5 enter pairing mode as shown:
Ensure RQ5 is off. Press and hold Mul-Funcon Buon
for approximately 8 seconds unl red and blue LED flash
rapidly ;
3) Using your Bluetooth device, please scan/ search for
available Bluetooth devices select “RQ5” from the list of
devices shown;
4) If prompted, enter password or PIN No: “0000”
5) If prompted by your mobile phone to connect, select
“Yes”(this will vary among mobile phone models)
6) Aer successful connecng, blue LED of headset will
flashes twice every 4 seconds
RQ5 can connect with two Bluetooth cell phones at the
same me. The general pairing procedures are as follows:
1）Pairing RQ5 with device A
2）Turn on RQ5 and make it enter pairing mode again,
and pairing it with device B
3）Operate device A to connect with headset. RQ5 has
already connected with two devices in this moment
While you’re listening to your music, you can control
your Bluetooth device with the below acon on your
RQ5 ear phones
Bluetooth version: CSR8635|V4.0+EDR
Bluetooth profiles: Headset, Hands free, A2DP, AVRCP
Operang distance: 10M
Talk me: 4-6 hours
Standby me: 150 hours
Charging me: about 1.5 hours
Charging Port: Micro USB
RQ5 built-in microphone allows you to answer and end
calls. Please use the chart below to execute your
desired funcon.
RQ5 comes with a built-in rechargeable baery, prior
to using it, it is recommended to charge the baery
fully for the first me.
1. Plug another side of cable to the USB port of PC or
into a USB power charger
- Red light on: Charging
- Red light off: Finish charging
2.It will takes about 1.5 hours to finish charging
1
2
3
4
5
6
Turning on:
Press and hold MFB buon about 4
seconds unl red LED flashes
Turning off:
Cancel a call
Answer a call
Reject a call
End a call
Redial the last
number
Call transfer
(headset to phone)
Call transfer
(phone to headset)
Microphone mute
Cancel mute
Short press MFB once
Short press MFB once
Short press MFB once
Double click MFB
Long press MFB about 2
seconds until you hear a
tone
Press and hold MFB for 2
seconds
Press and hold MFB for 2
seconds
Double click MFB
Double click MFB
Funcons Operaon
RQ5
Language switch (English Chinese)
RQ5 support language switch – When RQ5 on working
mode, press both “volume +” and ”volume -” together,
unl you hear “voice funcon switch” or “语音功能切换”,
then it can change the language of the voice prompt.
