XQ MAX QD7800260 User manual

MANUAL DART COUNTER

Thank you for purchasing this electronic darts scorer. Its computerized scoring
system makes game playing easy and enjoyable. With 40 built-in games and over
272 variations to choose from, both beginners and more advanced players will find
games to suit them. Up to 8 players can play at one time. Please read the
instructions before playing and be sure to save them for future reference.
MOUNTING INSTRUCTION:
Tools required:
! Pencil or marker
! Philips screwdriver
! Power drill with either:
- 1/16” (0.0625 inch) drill bit, or
- 1/4” (0.25 inch) drill bit
! 3 AA batteries
! Mounting screws with wall anchors (included)
! Level
! Stud finder (recommended to use a stud finder prior to drilling to locate studs)
The mounting location should be determined by where the scorekeeping will take place.
The Dart Scorer has a bracket to secure to a wall using two screw holes. The mounting
tab will be found at the middle of the back side of Dart Scorer. The Dart Scorer will be
positioned over the tab and slide down to mount onto the bracket.
BEWARE OF ELECTRICAL WIRES AND WATER PIPES WHEN DRILLING
THROUGH YOUR WALL

1. Find a spot that aside your dartboard that suit for installation. You need to locate
the stud first if you install it on a stud wall.
2. Put the mounting plate on the wall. Align it. Use a leveler if needed.
3. Use a pencil to mark the screw holes.
4. Drill the holes. If mounting it to a stud, use 1/16” drill bit. If there is no stud, use
1/4” drill bt and anchor.
5. Install two screws to the wall.
6. Slide the dart scorer to the mounting plate. Make sure it is secured in place.
This dart scorer also equiped with standing feet that you can use it as tabletop. Pull
standing feet from the slot at the back side of dart scorer, place it on the table.

POWER INSTALLATION:
The dart scorer is designed to be powered by 3 x 1.5v AA (LR6) batteries. The battery
compartment can be opened from the back to install the batteries. To conserve
batteries, this dart scorer is equipped with an auto power-off mode. If the dartboard is
not being used, it will automatically turn off after 30 minutes.
It also can be powered by an AC to 5V DC, 500 milliamp (minimum) adapter. For the
DC adapter, it is with the DC plug polarity configured as positive (+) outside, and
negative (-) center. To connect by adapter, plug the DC plug insert into the DC power
jack and the AC plug into an electrical outlet.
WARNING!
• Batteries should be replaced by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent types as recommended are to be
used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not dispose of in fire, in water or the general rubbish.

• During use, ensure the connecting cable does not present a tripping or other
hazard.
• After using, switch off the power at the mains and unplug the adapter from the
mains and dartboard.
• Never leave the adapter connected to the dartboard when not in use.
• Stow the adapter safely when not in use.
IMPORTANT NOTE
1. Under the environment with electrical fast transient the dart scorer may
malfunction and require use to reset the dart scorer.
2. Dart is an adult game which includes functional sharp point. Children should
only play under adult supervision.
Please peel off the protective film (if any) at the display area before use.
QUICK START:
1. Turn the Dart Scorer on by pressing the ON/OFF button. The default game is
G01 301 with 2 players.
2. Press the ENTER button to get to option selection, L01 (option) is
displayed. Use the UP or DOWN buttons if you would like to change
option.
3. Press the ENTER button again, 2-P (player number) is displayed. Use
the UP or DOWN buttons if you would like to change the number of
players.
4. Once selection is done, press the ENTER button to start the game.
5. Press and Hold the RESET button to return to starting page.

GAME MENU:
Game
Name
Options
Players
01
301
6
1 - 8
02
501
6
1 - 8
03
601
6
1 - 8
04
701
6
1 - 8
05
801
6
1 - 8
06
901
6
1 - 8
07
301 League
6
4 - 8
08
501 League
6
4 - 8
09
601 League
6
4 - 8
10
701 League
6
4 - 8
11
801 League
6
4 - 8
12
901 League
6
4 - 8
13
Cricket
3
1 - 8
14
No Score Cricket
3
1 - 8
15
Cut Throat Cricket
3
1 - 8
16
Killer Cricket
3
2 - 8
17
Scram Cricket
1
2
18
Low Pitch Cricket
3
1 - 8
19
English Cricket
1
2
20
Single Only Cricket
3
1 - 8
21
Count Up
9
1 - 8
22
Round the Clock
12
1 - 8
23
Shanghai
4
1 - 8
24
High Score
12
1 - 8
25
Overs
19
2 - 8
26
Unders
19
2 - 8
27
Halve-It
1
1 - 8
28
Big-6
19
2 - 8
29
Double Down
1
1 - 8
30
21 Points
7
1 - 8
31
Nine Dart Century
3
1 - 8
32
Best of Nine
5
1 - 8
33
3 Point Contest
2
1 - 8
34
9 Lives
7
2 - 8
35
Forty-One
1
1 - 8
36
Shoot-Out
19
1 - 8
37
Bingo
4
1 - 8
38
Killer
30
2 - 8
39
Shooting
1
1 - 8
40
All Fives
5
1 - 8

OPERATIONS:
1. Press the ON/OFF button to activate the Dart Scorer.
2. Press the UP or DOWN button until the desired game is displayed. Press
ENTER to confirm your selection.
3. Press the UP or DOWN button to select a game option. Press ENTER to
confirm your selection.
4. For the G01 to G12 games you can press the UP or DOWN button to select
Double In/ Out or Master Out. DI, DO and MO icons are displayed. Press
ENTER to confirm your selection.
5. Press the UP or DOWN buttons to select number of players. There are 13
selections of players from 1 player mode to 8 players’ mode, then scroll
through the 5 levels of the computer player: Beginner, Intermediate,
Advanced, Expert, Professional, and then scroll back to 1 player. Press
ENTER to start the game. For more than 2 players, some players will
share the player score display.
6. For some games, handicap mode can be selected. Player handicaps must
be set before pressing ENTER. When the number of players has been
chosen but before ENTER has been pressed, press the HANDICAP button
to cycle through the handicap options. Enter will save the settings and
move to the next page. The games that use handicap mode are listed
below.
No icons are lit up
Single In/Single Out
DI icon lit up
Double In/Single Out
DO icon lit up
Single In/Double Out
DI and DO icons lit up
Double In/Double Out
MO icon lit up
Single In/Master Out (double or triple)
DI and MO icons lit up
Double In/Master Out (double or triple)

Games with HANDICAP feature:
Game
Name
Options
Players
1
301
6
1-8
2
501
6
1-8
3
601
6
1-8
4
701
6
1-8
5
801
6
1-8
6
901
6
1-8
7
301 League
6
4-8
8
501 League
6
4-8
9
601 League
6
4-8
10
701 League
6
4-8
11
801 League
6
4-8
12
901 League
6
4-8
13
Cricket
3
1-8
21
Count Up
9
1-8
24
High Score
12
1-8
7. To enter a dart score, press the segment number that matches the
segment you hit. For a double, press X2 before the segment number. For a
triple, press X3 before the segment number.
8. Press VOLUME button to select the desired sound level.
9. When finishing a game, press ENTER to restart the game, or press and
hold the RESET button by 2 second to return to the beginning selection.
10. To switch off the game, press and hold the ON/OFF button for 2 seconds.
11. The Dart Scorer will automatically go into the power OFF mode if no button
is activated for 30 minutes.

BUTTON FUNCTIONS:
1. ON/OFF Button – Press ON/OFF to turn on the board. Press and hold ON/OFF
to turn the board off.
2. NEXT PLAYER Button – Press NEXT PLAYER to switch to next player after a
turn is finished.
3. RESET Button – Press RESET and hold for 2 seconds to return to the
beginning of the game. Player can select another game by pressing Up and
Down button.
4. MISS Button – Press MISS during the game to register missed darts.
Press and release to score 0 and record a dart thrown. P
5. VOLUME Button – Press repeatedly to scroll through 4 positions: Mute, low
volume, middle volume, high volume. Default at middle volume when the
power of the dartboard is turned on.
6. ENTER Button - Press ENTER to confirm the selection and start game.
7. QUICK CRICKET Button – Press QUICK CRICKET to select Game 13 Standard
Cricket directly.
8. HANDICAP Button – After selecting the number of players and before pressing
ENTER, use this button to select the players that will be receiving a handicap.
The UP and DOWN buttons are then used to select the level of the handicap.
9. UP button - This button is used to move upward through selections.

10. DOWN button - This button is used to move downward through selections.
11. Numbered buttons 1 thru 20, 25 and 50 - Use these buttons to enter the
segment hit by the dart. 25 is for a single bull and 50 for a double bull hit.
12. X2 button - Press before you press a numbered button to count the dart as a
double segment.
13. X3 button - Press before you press a numbered button to count the dart as a
triple segment.
DISPLAY FUNCTIONS:
1. Player Number - The number indicates the player that the cricket and score
display apply to.
2. Player’s Score - Display the current score for players 1, 3, 5 and 7.
3. Player’s Score - Display the current score for players 2, 4, 6 and 8.
4. Cricket Scoring - The Scorer utilizes a scoreboard display that keeps track of