Yakima HoldUp Evo User manual

$POUFOUT
tongue (1X)
wrench 2X washer (2X)
nut (1X)
spine bolt (1X)
Key (2X)
spine (1X)
spacer (2X)
front tray assembly (1X) rear tray assembly (1X)
tray bolt (4X) tray bolt (4X)
washer (4X)
washer (4X)
lock washer (4X) lock washer (4X)
HoldUp Evo
8FJHIUMJNJUT
Per Bike =50lbs. / 22.7kg
"WBJMBCMFBDDFTTPSJFT
#8002482
HoldUp EVO +2
(Works only with 2” Hitches)

,167$//$7,21
ALIGN
t Insert tongue into hitch receiver.
t The hole in the base must align to
the hole in the hitch receiver.
1
A
B
C
2 3
A. Insert the safety pin.
B. Tighten the knob COMPLETELY while wiggling the tongue.
C. Lock the knob (when locked, the knob will turn freely).
Tip: Use a permanent marker to draw a line on the
tongue, so that you know how far to insert the tongue
next time you install your carrier.
Affix the spacers to
the base as shown.
4Align the
spine with
the tongue.
Do not use with hitch adapters,
extenders, or reducers.

5 6
Install the spine bolt, washers, and nut.
You may need to wiggle the spine to
get the bolt to pass through. Then fully
tighten using the provided wrenches.
Remove the attachment
hardware from the tray
assemblies.
A
B
C
D
B
8X
34 Nm (25 ft-lbs)
7A. Place the the lower tray assembly into position. It's the
assembly with the large Yakima sticker. Orient the tray
so that the sticker is right side up.
B. Install the hardware and fully tighten to 17 ft-lbs (23Nm).
C. Place the upper tray assembly into position.
D. Install the hardware and fully tighten to 17 ft-lbs (23Nm).

3
Fold down the hook arms.
2
a
t Tuck wheelstraps under wheel cup.
t Load your heaviest bike first.
t Always load the first bike closest to the vehicle.
“click”
1b
Depress the tilt lever
with your foot, and
fold down the carrier.
Note: Carrier can fold down past
horizontal to aid in loading your
bikes.
Be TVSFUPSFUVSOUIFDBSSJFS
UPUIFMPDLFEIPSJ[POUBM
QPTJUJPOBGUFSMPBEJOH
CAUTION: *GBGFOEFSQSFWFOUTQSPQFS
QMBDFNFOUPGUIFXIFFMIPPLSFNPWFUIF
GFOEFSGPSQSPQFSBOETBGFMPBEJOH
Do not load a bike if it has a
flat tire or a slow leak. Lost
tire pressure may result in an
insecure load.
/2$',1*
Always support the spine
when lowering HoldUp EVO
when loaded with bikes.

4
7
>
Rotate the pivot arm up until the
hook rests on the bike tire 1” or
less from the brakes or the fork.
Failure to place wheel hook in the
correct position can cause your bicycle
to eject, and cause personal injury,
property damage, or death.
Feed the strap through the
spokes of wheel. Rotate the
wheel slightly, if necessary,
and avoid the valve stem.
Insert the strap end through
the buckle. Pull to tighten.
Compress the
hook against
the wheel by
applying firm
pressure.
6
Load Second bike (if applicable).
Alternate bike direction. Refer
to loading steps 3 through 6 to
load your second bike.
5
If you have bike to bike interference
when loading two bikes, adjust
trays as necessary to eliminate
interference between bikes.
t Loosen the 4 tray bolts (do
not remove bolts).
t Slide the tray left or right.
t Retighten the 4 tray bolts.
t Both trays can be adjusted.
4X

6/-0"%*/(
t Release the wheelstrap, and tuck it out of the way.
t Press the button, and raise the hook.
t While supporting the bike lower the hook arm.
t Carefully remove your bike.
$)&$,5)&*/45"--"5*0/
#&'03&%3*7*/("8":
IMPORTANT: For bikes with 20" wheels, if the wheelbase is less than 35", the rear wheel may not
contact the wheel cup (see image). Ensure that the wheel strap is pulled tightly, and secured in the
buckle. Also tires must be fully inflated, and centered on the tray.
t Push hooks against tires.
t Check that rear wheels are secured by the
ratchet straps.
t Be sure all hardware is secured according to
instructions.
t Always secure pivot arm when tray is empty
(see page 7).
8"MXBZTVTFUIFJOUFHSBUFEMPDLJOHDBCMFXIFOUSBOTQPSUJOHCJLFT
TVTQFOTJPOGPSL
CJLFGSBNF

3&.07"-
1. Unload bikes, fold in hoops, secure pivot arms.
2. Remove safety pin.
3. Unlock and loosen knob.
4. Remove carrier and store in a safe place.
Do not carry by the tilt levers.
8IFOOPUDBSSZJOHCJLFTBMXBZTGPME)PME6Q
&70VQ Pull the tilt lever and fold the HoldUp
EVO all the way up until it locks into position.
t 'PMEIPPQTJOXBSE
t 5JMUXIFFMUSBZJOCPBSE
t 3PUBUFQJWPUBSNEPXO
t 1VTIUIFIPPLTBHBJOTU
XIFFMUSBZT
4&$63&QJWPUBSNT
XIFOOPUJOVTF
“click”
a
b
Periodically it may be necessary
to adjust the tension of the
swing arms. Use a 5 mm hex
wrench to make the adjustment.
BOTTLE OPENER: Use the built
in bottle opener to enjoy a
refreshing beverage!
Careful:
Do not
overtighten!

+2/'83(92,6/,0,7('72/%63(5%,.(
,03257$17/2$'/,0,76
%POPUJOTUBMMPOUSBJMFSTDBNQFSTPS37T
%POPUJOTUBMMJGTQBSFUJSFDBVTFTJOUFSGFSFODFXJUICJLFTPSGPMEFEDBSSJFS
/PUGPSVTFPOCJLFTXJUIGSPOUGFOEFST
/FWFSESJWFPGGSPBEXJUICJDZDMFTMPBEFE
%POPUQPTJUJPOCJDZDMFUJSFTOFBSWFIJDMFTIPUFYIBVTU
%POPUVTFBOBVUPNBUFEDBSXBTIXJUIDBSSJFSJOTUBMMFE
%,.(6
t.BLFTVSFZPVSUJSFTBSFmMMFEUPSFDPNNFOEFEQSFTTVSFGPVOEPOUIFUJSF
t%POPUDBSSZUBOEFNPSSFDVNCFOUCJLFT
t%POPUUSBOTQPSUCJDZDMFTXJUIBUUBDIFECBCZTFBUTQBOOJFSTXIFFM
DPWFSTGVMMCJLFDPWFSTPSNPUPST
In addition, some
undersized receivers may
not accept this product.
If you do not know the
capabilities of your hitch
receiver, consult an
automotive professional.
Make the most out of your vehicle with Yakima. Check out the roof racks and cargo carriers we offer.