Yamaha ATS-1030 User manual

ATS-1030 Quick Start Guide
Supplied items
Before assembling and connecting, make sure you have received all of the following items.
If anything is missing, please call 888-892-6242, 8AM to 5PM PST Monday through Friday.
Placement
© 2013 Yamaha Corporation Printed in Malaysia ZK08370
Place the sound bar in front of or below your TV, either with or
without a stand, at least 2'' away from your TV.
The sound bar may also be mounted on a wall, using the
included mounting template and commercially available
screws. Refer to the Owner’s Manual for additional mounting
instructions.
NOTE
• Becarefulnottostackthisunitwithanyothercomponents,asvibration
may cause system disruption in other components.
Sound bar (ATS-1030) Mounting template
(Use when attaching the sound bar to a wall.)
Remote control Two AAA batteries
(Install the batteries in
the remote control.)
Optical cable
1.5 m (4.9 ft)
RCA stereo cable
1.5 m (4.9 ft)
Spacer × 2
(Use when attaching the
sound bar to a wall.)
Continued to the reverse side
Owner’s Manual

Connections
Optical cable
(supplied)
Set top box or playback device
(such as a Blu-ray DiscTM player)
Watching TV
For details, refer to the Owner’s Manual.
1. Press to turn on the sound bar.
2. Press the TV key to select TV as the input
source.
3. Select the desired input source on the TV.
4. Press the VOLUME (+/-) keys to adjust the
volume.
Playback of a Bluetooth® device
You can connect a Bluetooth device, such as a smartphone or
digital music player, with the sound bar wirelessly. For details,
refer to the Owner’s Manual.
... and more features!
For details about the other useful features, refer to the
Owner’s Manual.
– TV remote control learning function
– TV Remote Repeater
– Clear voice
– UniVolume
OPTICAL OUTPUT
Optical cable
(commercially available)
Sound bar
OPTICAL OUTPUT
HINT
In the following cases, connect the
optical output of the playback device
to the BD/DVD input of the sound bar
with an optical cable (commercially
available), then select the BD/DVD
key on the remote control for the input
source.
− The TV does not have an optical
output.
− The TV does not output audio (or
outputs low volume audio) from the
connected playback device.
− The audio from the playback device
connected to the TV cannot be
heard as surround sound.
Connect to an AC wall outlet.
Leave the unit powered off until
all connections are complete.
TV
1. Connect the TV and sound bar with the
optical cable (supplied).
Remove the cap of the optical cable and check the
direction of the plug.
2. Connect the power cable of the sound bar to
an AC wall outlet.
3. Turn on the TV and set the volume to
minimum.
4. Disable the TV’s built-in speaker output
(if available).
HINT
If a setting to disable the speaker output is not available on
your TV, you may disable it by connecting headphones to the
headphone jack on the TV. For details, refer to the instruction
manual of the TV.
The Bluetooth®word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Yamaha Corporation is under
license.
Blu-ray Disc is a trademark of the Blu-ray Disc Association.
HINT
If your TV is not equipped with an
optical audio output jack, connect your
TV to the ANALOG jack with the RCA
stereo cable (supplied).