Yard Craft POLY User manual

POLY ADIRONDACK
DINING CHAIR
ASSEMBLY MANUAL

Parts List
5/32” Hex Key
(included)
*NOTE: This Hex Key is used to tighten all the
screws used in the assembly process.
Tools Required For e Job
back
seat
2 front legs
2 armrests
2 back legs
hardware pack

4
Note: the back leg only receives one bolt
into the inset nut at this point. The
through hole will be used to fasten the
bottom of the back. Tighten this bolt
when installing the back.
Begin by placing the seat on a clean,
smooth surface.
Fasten front legs to seat using 1 1/2" bolts
(front legs are legs with two inset nuts).
Fasten back leg to seat using 1 1/2" bolts.
Step:2
Step:3
Repeat steps 1 and 3 on opposite side
then your chair should look like this. Do
not tighten bolts yet.
Step:1
Step:4

4
Prepare to install back by threading a
3" bolt into the empty hole on both
back legs. The bolt should only come
through a 1/8" to 1/4".
Fasten armrest to front and back leg
using 1 1/2" bolt. Arrows identify two
pre-drilled holes.
Tighten bolts. Then repeat steps 5 and 6
on opposite side. Tighten all bolts on
front leg.
Step:6
Step:7
Align pre-drilled holes with inset nuts
on bottom of back. Tighten.
Repeat on opposite side.
Step:5
Step:8

4
Fasten armrest to center of back using a
2 1/4" bolt. Tighten. Repeat on opposite
side.
Congratulations! Your assembly is now
complete. Your chair should appear like
this when finished!
Step:10
Step:9