
5Next level leisure
When you start pumping, the pressure gauge will not
start moving immediately. Continue pumping until the
pressure gauge indicates the correct pressure.
6 Installing the fin (SUP board)
• Fully inate the SUP board.
• Turn the SUP board over with the n box for the n
facing upwards.
• Push the n all the way into the n box (1)
• Push the pin through the side of the n box and the n.
You will hear a click. (2)
• Remove in the reverse order to the above.
3.2 Towing
Warning
If the inatable is being towed, this is only allowed
without persons on it and at a low speed.
The towing line must be attached to the ‘D’ rings:
• SUP board: 1 x on the underside at the front
• Platform: 4 x on top (at each corner)
4 Inflating
4.1 Preparation for inflating
• Ensure that the surface on which you inate is at
• Remove any sharp objects from the ground
• Unfold the inatable and spread it out at
note
Check that the valve is in the highest position. If this is
not the case, press the white cap with your nger and
turn it 90 degrees so the valve is raised
• Attach the pump to the valve and start inating
5 Pump operation
Double operation: double pumping power with red cap
installed for faster inating. When the red cap is removed,
it becomes a high-pressure pump to inate the board to
the recommended pressure.
The outlet above the pressure gauge on the pump is
for inating, the outlet under the pressure gauge on the
pump is to vacuum.
The pressure gauge needs a minimum counter pressure
of 0.5 bar. The needle will not move below that. If you
doubt whether the pressure gauge is working, remove
the hose from the pump, hold the palm of your hand
rmly against the outlet for inating and pump once by
pressing the handle downwards. The pressure gauge will
move immediately.
Warning
Do not use compressed air for inating (such as a
tyre compressor).
Do not expose the inatable to direct sunlight if it is not
in the water because the air expanding may result in
damage or explosions.
If the pressure is too high, it may lead to structural (irrep-
arable) damage.
Working pressure: 15 psi / 1,0 bar
Maximum pressure: 20 psi / 1,4 bar
Minimum pressure: 10 psi / 0,7 bar
1 2
7 Leash - How to properly attach
the leash to a board
Leashes provides safety, it prevents that the board gets
away from you when you fall of it.
7.1 Board attachment point
The leash must be attached to the D- ring which is at
the tail of the board. The leash has a ‘nylon’ string/ cord,
which goes under the D- ring and then looping it through
itself.
note
Besides the D- ring at the tail there are several other D-
rings on the board, but these are for other purposes,
like storage of cargo or mounting a kayak seat. They
can’t be used for attaching a leash.