Zenith Air ZODIAC 601 User manual

●Cut along leading edge of vertical
stabilizer
●Cut along four lines above canopy in front
and in back
●Fold paper inward between fuselage
halves.
Zenith Aircraft
ZODIAC 60
Main Spar and Main Gear
Cut out
Copyright 2005, 2006 Gary B. Anderson, All rights reserved

Builders Manual
Zenith Aircraft Company
CH 601 Paper Airplane

STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Cut out
Page 2
Fold paper in half
Take care that the
fold is symmetrical
A trick to doing this
is to back light the
paper and line up
the wing panels
Fold paper in half
Take care that the
fold is symmetrical
A trick to doing this
is to back light the
paper and line up
the wing panels
Cut the model out
using either
scissors or a sharp
knife Fold the
main spar in half
before cutting
Folded Model
Cut out model

Fold spar in half
again
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Wing Spar and Fuselage Tabs
Page 3
Fold fuselage tabs
along fuselage to
both sides
Wing spar and wheels
Fuselage tabs

Fold forward
fuselage tabs
inward
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Fuselage Tabs
Page 4
Fold rearward
fuselage tabs
inward
Forward fuselage tabs
Rear fuselage tabs

Fold wings and
horizontal
stabilizer outward
Tape edges of
fuselage
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Wings and Main Gear
Page 5
Bend gear legs
down and place
spar and gear on
tape
Fold wings and horizontal stabilizer
Main spar and gear legs

Tape spar and
gear to wing as
shown
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Main Spar and Gear
Page 6
Tape front gear to
strengthen as
shown
Tape spar and gear to wing
Front gear

Acquire an engine
The CH 601
requires three
paper clips Place
engine on cowling
alternating the
smaller loop side
to side
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Engine and Leading Edge
Page 7
Form the leading
edge of the wing
Use a sharp
straight edge to
make three
creases in the
leading edge
Engine
Form leading edge

The leading edge
should look like
this
STOL
CH 601
Zenith Aircraft Company
www.zenithair.com
Revision 0.0 09/22/07)
© 2007 Gary B. Anderson
Leading Edge and Trim
Page 8
Bend down the
flaps a bit Bend
up the elevators a
bit and you are
ready to fly!
Leading edge profile
Trim