Zeon CE3410 User manual

Rolling Alarm Clock Instruction Manual CE3410
Congratulations on purchasing the Rolling Alarm Clock with Musical Alarm and Rolling
functions. Please take time to read the instructions below.
Functions
- LCD Clock Display
- Alarm Function (15 minutes continuous Alarm)
- 10 Musical Alarm setting
- Rolling function
- Backlight
- 3 X AAA batteries (not included)
Installing batteries
Your clock requires 3 X AAA batteries; follow below procedure and refer to the diagrams to install batteries
1. Slide the safety catch and turn the front clock part in the direction of the arrow.
2. Gently remove the main section of the clock to locate the battery cover.
3. Use Phillips screwdriver and carefully loosen the two screws from the battery compartment cover.
4. Install 3 X AAA batteries observing the correct polarities, making sure that the batteries pull out ribbon is under the
batteries.
5. Now safely place the battery cover back into the position, making sure the access battery pull out ribbon is folded
over the batteries.
6. Now secure the battery compartment cover tightening the two screws.
7. Replace the clock cover and lock it into the position.
Battery Precautions
•Do not mix different types or old and new batteries.
•Only use batteries of the same or equivalent type recommended.
•Batteries should be inserted with the correct polarity.
•Exhausted batteries are to be removed.
•The supply terminals are not to be short circuited.
•Do not use re-chargeable batteries.
•Do not mix Alkaline, standard or rechargeable batteries.
•Batteries should be replaced by an adult.

Clock Front: Clock Back:
Function Setting Keys
•Key A Main Key – To interchange between Time, Alarm, Music & Rolling Setting & Back light mode.
•Key B1 & B2 Keys – To increment and decrement the digits when setting.
•Key C - Reset key – By using a pointed device press the reset key to reset the clock to factory’s setting.
Display Icons
(a) Clock Time Setting.
(b) Alarm Setting.
(c) Alarm Music Selection Setting.
(d) Rolling ON/OFF Setting.
Press Key A to switch between different modes .
Time Setting
1. Press Key A to select the time setting mode, flashing clock icon will be displayed.
2. Press and hold Key A for 3 seconds to enter time setting mode. The clock icon will stay static and hour
digits will flash.
3. Press Key B1 or B2 to set the hours.
4. Press Key A to move to the minutes setting and minute digits will flash.
5. Press Key B1 or B2 to set the minutes.
6. Press Key A to move to AM/PM setting, AM/PM icon will flash.
7. Press Key B1 or B2 to set time to AM or PM.
8. Finally press and hold Key A to complete setting and after few seconds clock icon will automatically stop
flashing and this will confirm the settings.

Note:
- While setting if no buttons is pressed after few seconds the clock will automatically exit the setting
mode.
Alarm Music & Rolling Function
- Alarm Music Selection - This clock has a built in 10 different music alarms. The selected music will be played
when the alarm time is reached.
- Rolling Function – The clock has a rolling function where the clock will roll on to the cradle when the alarm time
is reached. This function can be turned ON or OFF when setting the alarm. This function may result in clock
rolling off from the cradle to floor which is normal. This is a design feature as it forces you to pick up
the clock and put back onto the cradle.
Setting the Alarm Music
1. Press Key A to select the alarm music mode, flashing music note icon will be displayed.
2. Press and hold Key A for 3 seconds to enter the alarm music setting mode. The music note icon will stay
static and the digits will flash.
3. Press Key B1 or B2 to select desired alarm music.
4. Finally to confirm your selection press and hold Key A, the music digit will be static and the music note icon
will flash. After 5 seconds the music note icon will automatically stop flashing and display will return to
normal time display.
Alarm Setting
1. Press Key A to select Alarm setting mode, flashing bell icon will be displayed.
2. Press and hold Key A for 3 seconds to enter alarm setting mode. The bell icon will stay static and hour digits
will flash.
3. Press Key B1 or B2 to set hours.
4. Press Key A to move to the minutes setting and minute digits will flash.
5. Press Key B1 or B2 to set the minutes.
6. Press Key A to move to AM/PM setting, AM/PM icon will flash.
7. Press Key B1 or B2 to set time to AM or PM.
8. Press Key A to move to rolling setting, rolling icon will flash.
9. Press Key B1 or B2 to set the rolling feature to ON or OFF.
10. Press Key A to confirm all setting.
11. Finally press and hold Key A to complete setting and after few seconds the bell icon will automatically stop
flashing and display will return to normal time display.

Note:
- While setting the alarm if no buttons is pressed after few seconds the clock will automatically exit the
alarm setting mode.
- When the alarm and rolling function is activated both the alarm and rolling icons are
displayed on normal time display.
Activate and Deactivate Alarm & Rolling function
When the alarm sound the selected music will play. Press any key to stop the alarm and by default the alarm will sound
again after 1 minute. To permanently stop the alarm press and hold Key B1 and B2 simultaneously for 3 seconds,
display will show “OFF” icon. To re-activate the alarm to the same time press and hold Key B1 and B2 simultaneously for
3 seconds, display will show “ON” icon.
Backlight
Press any key to turn on the backlight. The light will be automatically off in approx 8 seconds.
SAFETY WARNING / CHOKING HAZARD
Not suitable for children under 3 years due to small parts. Adult supervision is recommended when changing batteries.
Remove all packaging attachments and safely dispose of before giving this toy to a child. Please retain manual for future
reference.