ZETR 25 User manual

25 INSTALLATION MANUAL /PAGE 1 OF 2 / 100522
WWW.ZETR.COM.AU / [email protected]
TOOLS REQUIRED
IN THE BOX



 


 


 


 


 


 




 





 












WARNING
DANGER
ATTENTION
25 POWER & DATA SYSTEM




NOT INCLUDED]







25 INSTALLATION MANUAL /PAGE 2 OF 2 / 100522
To set the height of the mechanism grid place the levelling washers onto the it
so they’re concentric with the levelling fasteners. [see g.6]. Adjust until the top
of the washer is in-line/ush with the surface
INSTALLATION GUIDE
3
4
NOTE To remove the faceplate press down on one end to break magnet. The
faceplate will pop up for ease-of-removal
Remove the faceplate from the product assembly and safely store until required.
1
ATTENTION We recommend that the slot cut-out in your substrate
is laser, waterjet or CNC cut. Please ensure clearance considerations are
made in relation to the undercarriage footprint.
2
Using the leveling fasteners adjust the height and tilt of the mechanism grid
WARNING A Philips Head 1 [PH1] screwdriver can only be used to adjust
the leveling screws – using any other driver size or type will damage/cause the
leveling screw to jam.
From the back side of your substrate, align the mechanism grid assembly
with the cut slot
Using self-tapping or metric screws fasten the undercarriage to your
substrate ensuring that there is an equal amount of clearance between the
mechanism grid and cut slot.
N.B. Consult your substrate fabricator or contractor for best fastening method.
Fit the faceplate onto the mechanism grid ensuring the notch in the faceplate
aligns with the notch in the grid, the faceplate is secured by magnetic clasp.
7
8
5
ATTENTION Prior to mounting check all cables between power supply unit
and mechanisms are fully engaged and terminate all data services
6