Ziamatic Zico SURE-GRIP XL SG-VM-XL Parts list manual

ZICO®
3085PM3
SURE-GRIP XL™


ITEM PART NUMBER DESCRIPTION QTY.
1 3085-505-105 SURE GRIP BASE 1
2 3085-505-107 STRAP PLATE 1
3A 3085-505-109 STRAP, STANDARD 19.5" (SG-VM-XL) 1
3B 3085-510-109 STRAP, SHORT 15.5" (SG-VM-XLS) 1
4 9125-191306 SCREW, #6-20 x 3/8", PLASTIC THREAD
CUTTING, SS, 94629A70
4
5 9010-262528 SCREW, 1/4-20 x 2" TRUSS HEAD ZPS 2
6 9013-172500 NUT, 1/4-20 HEX HEAD, LOW-PRO NYLON
LOCK, ZPS
2
7 9014-262500 LOCK WASHER, 1/4" EXTERNAL TOOTH,
ZPS
2
8 9014-161600 FENDER WASHER, #8 X 1.000 O.D. ZPS 1
9 3085-505-901 PAD WITH ADHESIVE, 3" x 4" 1
10 9014-112500 FLAT WASHER, 1/4" ZPS 2
MODEL DESCRIPTION
WT./@
IN LBS.
SG-VM-XL SURE-GRIP XL Bracket - 3" - 4" grip range .90
SG-VM-XLS SURE-GRIP XL Bracket - 2" - 3" grip range .90
REV. 4-19-21
*
* Figures shown with 19-1/2" strap (SG-VM-XL). 15-1/2" Strap (SG-VM-XLS) is similar.

Page 2

Page 3

Ziamatic Corp.
10 West College Avenue, P.O. Box 337, Yardley, PA 19067-0587 • [phone] • FAX: [phone]
.

TOLL FREE: 800-711-3473
Page 4

Note: Part numbers in parentheses (see Page 1).
I. INSTALLATION
1. When using two SURE-GRIP mounts to secure one tool, it is suggested to space the mounts
approximately shoulder-width apart to allow for quicker and easier operation
2. Attach Base to mounting surface using Truss Head Screws (5) combined with 1/4"
nuts (6) and washers (7)(10). Use longer screws if needed.
 3.AdherethePad(9)totheatportionofBase(seePage3).
.
II. SECURING THE TOOL
 1.PlaceandholdthetoolagainsttheBase.Wheninahorizontalconguration,support
arm may be used for assistance and stability.
2. Place the Strap (3) over the tool. Wrap it around the oval-shaped post from the side
(see above).
3. While maintaining tension on the strap, pull away from the Base to tighten, then
connect the hook pad and the loop pad to secure.
III. 
1. Grab the end of the strap at the red tab and pull away from the Base to release the
hook & loop connection.
2. Pull the tool towards you, through the loosened strap. Strap will free itself as you
pull.
