Zico SURE-GRIP SG-VM-1 Parts list manual

ZICO®
3085PM2
SURE-GRIP™

 Rev. 1-6-21
ITEM PART NUMBER  
1 3085-500-105 SURE GRIP BASE 1
2 3085-500-107 STRAP PLATE 1
3 3085-500-109 STRAP. VARIABLE 1
4 9125-191306 SCREW, #6-20x3/8", PLASTIC THREAD
CUTTING, SS, 94629A70
4
5 9010-262520 SCREW, 1/4-20x1 1/4" TRUSS HEAD ZPS 2
6 9013-172500 NUT, 1/4-20 HEX HEAD, LOW-PRO NYLON
LOCK, ZPS
2
7 9014-262500 LOCK WASHER, 1/4" EXTERNAL TOOTH,
ZPS
2
8 9014-161300 FENDER WASHER, #6 X .560 O.D. ZPS 1
9 3085-500-901 PAD WITH ADHESIVE 1
10 9014-112500 FLAT WASHER, 1/4" ZPS 2
 


SG-VM-1 SURE-GRIP Bracket - 3/4" - 1-3/4" Dia. grip range .25

Page 2

Page 3

Ziamatic Corp.
    
.

  
Page 4

Note: Part numbers in parentheses (see Page 1).

1. The support arm on the Base (1) should be positioned toward the bottom of the
 compartment,inbothhorizontalandverticalstoragecongurations.
2. When using two SURE-GRIP mounts to secure one tool, it is suggested to space the mounts
approximately shoulder-width apart to allow for quicker and easier operation
3. Attach Base to mounting surface using Truss Head Screws (5) combined with 1/4"
 nuts(6)andwashers(7)(10).Iflongerscrewsareneeded,uselowproletrusshead
screws.
 4.AdherethePad(9)totheatportionofBase(seePage3).
.

 1.PlaceandholdthetoolagainsttheBase.Wheninahorizontalconguration,support
arm may be used for assistance and stability.
2. Place the Strap (3) over the tool. Slide it behind the oval-shaped post from the side
(see above).
3. While maintaining tension on the strap, pull away from the Base to tighten, then
connect the hook pad and the loop pad to secure.

1. Grab the end of the strap at the red tab and pull away from the base to release the
hook & loop connection.
2. Pull the tool towards you, through the loosened strap. Strap will free itself as you
pull.
