ZMODO ZP-NE14-S User manual

ZP-NE14-S (sPoE)
How to Repair The Cable on a Simplified POE
Camera
**Warning** Cutting the end off of a camera or cable will VOID
the warranty on that item. **Warning**
**if your cable end is defective this is covered under warranty, create your
warranty online at http://www.zmodo.com/rma or contact our support department**
The cable pinout on the Simplified POE camera is different from the stanrard LAN
cable because only four out of the eight cables within the LAN cable are actually
used.
If the cable on the camera is damaged and needs to be replaced, please use the
diagrams above to model how to reinstall the cables into the pin positions.
Page 1 / 2
(c) 2023 Jeremy Schultz <[email protected]> | 2023-01-06 10:46
URL: https://kb.zmodo.com/index.php?action=artikel&cat=164&id=333&artlang=en

ZP-NE14-S (sPoE)
Pins 1 and 6 are power, pin 1 is negative and pin 6 is positive. Pins 2 and 3 transmit
data to and from the camera.
**Please do not use this diagram to create a pinout for a separate power source for
the Simplified POE cameras. The cameras use a proprietary data communication
protocol, therefore the only way to power on the camera is to directly connect it to
one of the back ports on the the Simplified POE NVR.
Unique solution ID: #1333
Author: Amanda Mayer
Last update: 2015-03-30 12:21
PoweredbyTCPDF(www.tcpdf.org)
Page 2 / 2
(c) 2023 Jeremy Schultz <[email protected]> | 2023-01-06 10:46
URL: https://kb.zmodo.com/index.php?action=artikel&cat=164&id=333&artlang=en