Zorg Effects Zorglonde User manual

Zorglonde
S’resu launam
Please read carefully this manual as it contains important infos. It’ll help you to use the Zorglonde
at it’s best.
Please feed the love philter with a 9v center negative power supply. Consumption is 31m max.
Tuoba eht s'ladep dnuos.
The Zorglonde is a vintage tremolo which seeks to color nicely your sound. It allows to use to types
of tremolo waves shapes, square and sine, and allow to sweep a very large rate span (from 1Hz to
16Hz, or 60bpm to 960bpm).
The sine wave shape is based on vintage tube bias tremolo. It produce a sweet and colorful
tremolo.
The square tremolo is harsher and more of an optical tremolo with less color.
In both cases, with an instrument with high output level, the pedal may saturate a bit. If you wish
to adapt the pedal to your input level and remove or add saturation, a pair of small switches are
available under the pedal. (See next chapter)
nd last, the rate of your tremolo can be swept with an expression pedal, allowing psyche or dub
effects.
Tpada ruoy ednolgroZ ot eht tupni level.*
(*Adapt your Zorglonde to the input level)
Under the pedal lies two mini switches which allows to trim the distortion of the Zorglonde
according to your input level. Please note that a change of this switches will change your output
volume. (That’s also why there’s a volume knob…)
The “OFF-OFF” position allows the Zorglonde to generate almost no distortion. Even with high
instrument levels (Ex: a guitar with modern humbuckers). But in this position the signal/noise ratio
is not the best, if the pedal is before a high gain distortion, it’s likely you’ll ear a tiny bit of the LFO.
The “ON-ON” position, on the contrary has the best signal to noise ratio. But it’s the position which
will give the most distortion. It’s the best position if the pedal is before a high gain distortion, or if
your instrument output is low. Note that if you have very low output instrument (ex: a guitar with
vintage single coils) you may never achieve to saturate the Zorglonde.
The positions “ON-OFF” and “OFF-ON” positions offers intermediate possibilities between the two
upper cases. They may be interesting if you have a medium output instrument (like a P90 pickups
guitar or vintage humbuckers) or if you want to have a tiny bit of grit.

Tahw era eseht sbonk ro ?
Sq/Sin: Or □|O. This switch allows to select a square or sine wave shape. The square wave shape
really can squash the sound, whereas the sine one is sweeter.
LOV: Sets the pedal output volume.
ETAR: Trims the rate of the tremolo. This knob sweeps frequency from 1Hz to 16Hz. If an
expression pedal is plugged in the EXP input, this knobs sets the maximum rate achieved when the
pedal is fully pressed.
HTPED : This knob sets the depth of the tremolo. It’s course is slightly different according to the
wave shape. lso with a sine wave shape, when HTPED is above 3 o’clock, the tremolo changes
from sine to a pulse like tremolo. With high rates (ET R above 3 o’clock) a volume loss is expected
if HTPED is above 3 o’clock (it’s normal).
EXP: The jack input allow to plug an expression pedal. 25k log expression pedal would be best,
but they’re not easy to find. Classic 10k lin pedals (Like the Roland EV-5) works as well.

A we steserp:
(With small switches under the pedal in OFF-OFF con iguration)
ZorglO_O_O_O_Onde Bubbles
Good Vibes Repeats