ZUUM Media HE2-50M Series User manual

8805 Jones Rd. Ste C104, Houston Texas 77065 * 1-888-861-7351 * www.zuummedia.com ZM 082213
Model: HE2-50M
____________________________________________________________________________________
HDMI Extender over Two CAT5/6 Cables 1080p/3D up to 164ft (50m)
The HE2-50M uses only two cost effective CAT5/6 cables to extend your HDTV display up to 164ft (50m) at 1080p, with high
quality uncompressed video,it delivers significant value to the entire home and commercial entertainment system. This HDMI
extender only needs one power supply connected at the receiver side. For a closer TV installation, use the included USB
power cable that will pull power directly from your display device. Easy setup and optimal signal,Auto EQ level and Auto
EDID, no dials or dip switches to adjust.
Extends HDMI over two CAT5/6 cables (CAT6 recommended for best results)
Full HD 1080p@60Hz and 3D, Deep Color up to 36bit
Max Data Rate –6.75Gbps
Supported Audio –LPCM, Dolby AC3, Dolby TrueHD, DTS-HD
Bi-Directional IR (Optional)Model: IR-RXTX, carrier frequency 30kHz to 60kHz
HDMI and HDCP compliant
Transmission range up to 164ft (50m)
Auto EDID and EQ no dials or dip switches to adjust
Powered at the receiver by USB power cable or power supply
Easy to install, Plug n Play, Small form factor
Connection and Operation:
Before installation, please make sure all devices you are connecting are turned off.
1) Connect your source to the transmitter extender using an HDMI cable
2) Connect your display to the receiver extender using an HDMI cable
3) Connect up to 164ft (50m) CAT5/6 cable from the transmitter extender to the receiver extender
4) Connect the 5VDC power supply or USB power cable to the receiver extender
5) Turn on your source and display, then check extender input/output status lights
Installation View:
Note: In limited space applications a special USB power cable (Included) can be used which will pull USB power from the TV or source
component instead of using supplied power supply. This extender will require an (Optional) IR Receiver and IR Blaster (IR-RXTX Kit) for
the IR control function to work.
Transmission Range: If connection is through a wall jack (not recommended),this could limit the full transmission distance
between the Transmitter and Receiver Extender. We recommended using a straight CAT5/6 cable with RJ45 connections on
each end.
____________________________________________________________________________________

8805 Jones Rd. Ste C104, Houston Texas 77065 * 1-888-861-7351 * www.zuummedia.com ZM 082213
Shielded Cable: On most installations, we recommended using a Shielded CAT5/6 cable with properly connected shielded
RJ45 connectors. This will prevent video and audio loss due to EMI and other interference from switched lighting and ceiling
fans.
Caution:
1. The wiring must be away from any equipment with electromagnetic signal, such as mobile phones, microwaves, radio
communication equipment, fluorescent lighting, and high voltage power lines.
2. This device is not network compatible; do not connect via Network to avoid damage.
IR Control Connections:
-Step 1: When using your IR remote pointed at the display side, plug the IR Receiver into the Receiver Extender.
Then on the source side,plug the IR Blaster into the Transmitter Extender.
-Step 2: When using your IR remote pointed at the source side or,plug the IR Receiver into the Transmitter
Extender. Then on the display side,plug the IR Blaster into the Receiver Extender.
Status Lights:
HDMI Output LED (Red) - ON: Video sync established from Receiver Extender to display
OFF: No sync or bad connection
HDMI Input LED (Blue) - ON: Video sync established from source to Transmitter Extender
OFF: No sync or bad connection
Panel View:
___________________________________________________________________________________

8805 Jones Rd. Ste C104, Houston Texas 77065 * 1-888-861-7351 * www.zuummedia.com ZM 082213
Model:
HE2-50M-TX
HE2-50M-RX
Resolution
Up to 1080p@60Hz
Distance
164ft (50m) Max
Deep Color
24bit/36bit
HDMI Connector
Type A
Power Supply
5VDC 1.2A
Power Consumption
500mA Max
Operation Temperature
Operation: 5 to 131°F, Storage: -4 to 185°F, Humidity: up to 90%
Dimensions - Inches
3.25(w) x 1.80(h) x .87(d)
Weight - lbs
.28
.28
RJ45 Define:
Package Contents:
-HDMI Transmitter
-HDMI Receiver
- 5VDC 1.2Amp Power Supply
-USB Power Cable
-IR Receiver (Optional)
-IR Blaster (Optional)
-User Instructions
Specifications:
____________________________________________________________________________________
Do You Need Technical Support?
ZuumMedia is proud to offer free technical support to ensure your product is operating correctly.
If you are experiencing difficulties setting up this product, please call us for assistance 1-888-861-7351 or visit www.zuummedia.com for
more information.
Here for You 24/7