1 BY ONE O0000-0555 User manual

Amplified VHF & UHF Combo TV Antenna
with J-Pole Mount
SKU: O0000-0555
What’s in the box?
Antenna Specification
PSU Specification
18dB 465mm
8
Frequency
Range Impedance No. of
Elements
Amplifier
Gain Noise Figure Antenna
Length
174-230MHz
470-862MHz
3-5dBi
8-10dBi <4dB
O
0-40 C
0.8dB
40-862MHz
Power Input Power Output Insert Loss
Operating
Temperature
Range Short-circuit Protection
Orange LED turns red
if short-circuit happens
How To Install
Step 1. Unfold the VHF elements (U-shape, next to the bracket) until they're at right angel to the
plas c boom, then fix them with the wing nuts (Refer to Graph. A).
Step 2. A ach the antenna to a pole towards the direc on of your local TV tower, then fix it with
the bracket an ghten the wing nuts (Refer to Graph. B).
Step 3. Use a piece of coaxial cable to connect the F connector on the antenna, and the F connector
on the PSU marked “IN”.
Step 4. Use a piece of coaxial cable to connect the F connector on the PSU marked “ TV”, and the
Antenna Input on your set-top box or digital TV set.
Step 5. Plug the PSU into a socket, turn on your TV and run a channel scan. If you’re not receiving all
your local channels, you may try to adjust the direc on of the antenna in order to find out the
correct direc on of your local TV tower. Don’t forget to re-scan the channels ever me you
change the antenna’s direc on.
STB
or T V
IN
TV
AC110V 60Hz DC12V 100mA
Antenna x1 Power Supply Unit (PSU) x1 1.5m coaxial cable (from PSU to TV) x1 21" J-shape Pole x 1
Mounng Base x 1 User Manual x 1 Φ6*19mm screw x 2 Φ6*43mm screw x 1
Φ6mm hexagon nut x3 Φ7*45 mm Plasc Anchor Bolt x 2

How to install the J-shape Pole
Mounted on ground Mounted on wall
Step 1. Place the J-pole into the moun ng base, matching the screw holes. Put the
6*43mm screw through the moun ng base and the pole from one side to the other,
and the ghten the nut.
Step 2. Put the two Φ6*19mm screws inside the J-poe and make them come out from
the holes on both sides, an ghten the nuts slightly. Adjust the pole to the suitable
posi on an ghten the nuts firmly.
Step 3. Fix the moun ng base on the wall or ground with the plas c anchor bolts.
1byone Products Inc.
2313 E, Philadelphia Street, Unit M, Ontario, CA 91761
www.1byone.com