3devo SHR3D IT User manual

1. Power socket
2. Power switch
3. High current indicator
4. High temperature indicator
5. Start button (green)
6. Reverse button (white)
7. Stop button (red)
8. Emergency button
9. Interlock guard
10. Granulate collector
11. Granulator compartment
12. Shredder compartment
13. Hopper locking lever
14. Hopper
What is where?
What is in the box:
SHR3D IT
Hopper
Granulate collector
Power cable
Quick start or complete manual
In this quick start you will nd the essential instructions
to set up your SHR3D IT, right out of the box.
For more detailed information about the functions and
applications of the SHR3D IT, you can visit
our website:
www.3devo.com/manuals
11 141 2 3 4 6 7 8 10 139 125

Warranty Support
For information about the
3devo warranty policy visit:
www.3devo.com/warranty
For more information or
technical support visit:
www.3devo.com/support
Set up the Shredder
Remove the packaging
Remove the top accessory box. Then remove the top foam
blocks. Lift out the SHR3D IT with two persons and place it on
a at surface. Finally remove the plastic cover bag from the
SHR3D IT.
6) Check if both indicator lights are turned
on.
7) Press the green button down for one
second to start the machine.
8) Throw in plastic parts and wait until the
part is processed into granulate.
9) Press the red button down to stop the
machine.
10) Open the interlock guard to slide out the
granulate collector.
3) Slide the granulate collector in. 4) Close interlock guard.1) Push hopper locking lever down and slide
hopper inside. Release lever to lock the
hopper in place.
5) Plug in the power cable and turn on the
power switch at the back of the machine.
2) Open interlock guard.
Wrong use of the machine and/or manipulating safety
switches may lead to severe injuries or failure of the
machine. The manufacturer is not liable for any problems
caused by the user’s failure to observe the instructions stated
in the manual.
Check if the voltage in your power socket corresponds to that
of the purchased product.
Always wear personal protective equipment during use of
the machine. Wear ear protection, safety glasses and cut
resistant gloves when working with knives. Wear a gas mask
when working with plastics that release toxic gasses or dust.
Never change or remove guards when the machine is
powered.
Do not shred non-plastics.
Thoroughly read and adhere to ALL the safety instructions
as stated in the manual:
www.3devo.com/manuals
Safety instructions