3idee ass-mxaq User manual

www.3idee.eu
ass-mxaq VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following products from
Asus(asus.com): Designo MX27AQ, Designo MX279HS, Designo MX27UCS.
The VESA adapter allows you to conveniently mount your ASUS brand monitor to a
monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and
nuts.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
First, remove the base of your Asus monitor. To do this,
loosen the screw under the monitor base. (Figure 1)
Please make sure you have a soft surface when you
store the monitor for disassembly / assembly.
Figure 1
Step 2
Now slide the 3idee VESA adapter onto the foot from behind,
as shown. (Figure 2)
It is important that the hole in the VESA adapter is
aligned with the hole in the monitor base. (follows in
step 3)
Figure 2

3Assembly instructions
Step 3
Now screw the screw + washer + spring washer into the rear
monitor base from below. (Figure 3)
Please pay attention to the correct order of the
washers. This is important for the permanent safety
of the assembly.
Figure 3
Step 4
Now the monitor + VESA adapter can be screwed to your
VESA arm. (Figure 4)
Please use the 4 screws included in the scope of delivery.
Figure 4
Step 5
Finally, please check again whether all screws have been
tightened correctly.
However, please keep in mind that this is a plastic part.
Figure

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)