3idee VESA de-2318us User manual

www.3idee.eu
de-2318us VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following products from Dell (dell.com):
S2218H, S2218HN, SE2219H, SE2219HN, S2318HN, S2318H, SE2319HN,
SE2319H, S2418H, S2418HN, S2421NX, S2419HN, S2419H, S2718HX,
S2718HN, S2718NX, S2721H, S2721HN, S2721NX.
With the VESA adapter, you can easily mount your DELL brand monitor to a
monitor arm with VESA hole pattern (75 x 75mm). Use the included screws and
nuts for this.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
Remove the base of your monitor if it is already attached.
Step 2
Now place the monitor with the back facing up on a soft, safe
surface and slide the VESA adapter into the screen as shown.
(Figure 1)
When you hear a "click" sound, the adapter has successfully
snapped into place and is securely connected to the monitor.
Figure 1
Step 3
Make sure the metal plate on the 3idee VESA adapter is
correctly centered when inserting it into the monitor.
Figure
Step 4
Check again if the VESA adapter is firmly connected to the
monitor. (Figure 2)
Figure 2

3Assembly instructions
Step 5
Now hold the VESA adapter on your monitor arm and screw
it tight from behind with the other hand. (Figure 3)
Figure 3
Step 6
When fully assembled, it should now look as shown. (Figure
4)
Figure 4

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)