3idee vs-vx24 User manual

www.3idee.eu
vs-vx24 VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following products from VIEWSONIC
(viewsonic.com): VX2458-C-MHD Curved Gaming Monitor.
The VESA adapter allows you to conveniently mount your VIEWSONIC brand
monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included
screws and nuts.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels. (not included in the scope of delivery).

2
Assembly instructions
Assembly instruction
Step 1
Place your monitor flat on a soft and safe surface. Now
remove the base by unscrewing the screw underneath the
base. (Figure 1)
Figure 1
Step 2
Now move the foot to the upper stop, this is important so
that the monitor later hangs straight on your monitor arm /
VESA arm. (Figure 2)
Figure 2
Step 3
Now plug the 3idee VESA adapter onto your monitor. (Figure
3)
Make sure the black plastic piece is properly seated on the
monitor base.
Figure 3
Step 4
This is how the correct position of the VESA adapter looks on
the base. (Figure 4)
Figure 4

3Assembly instructions
Step 5
Now it is important that all holes of the VESA adapter are
aligned with the hole in the monitor base. (Figure 5)
Hold the VESA adapter in this position to proceed to the next
step.
Figure 5
Step 6
Now take the M6x25 + washer (largest screw in the
package) and screw it into the VESA adapter as shown.
(Figure 6)
Figure 6
Step 7
We recommend you to do this step with a second
person.
Now take the monitor + VESA adapter and screw it to your
VESA arm. (Figure 7)
Figure 7
Step 8
Please make sure that all 4 screws are tight. (Figure 8)
Figure 8

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)