3xLogic VSX-1.3MP-PIR1 User manual

Quick Reference Guide
How to Setup the VSX-1.3MP-PIR1 on Wi-Fi.
VSX-1.3MP-PIR1 Camera

Quick Reference Guide
Page 2
To properly set up the VSX-1.3MP-PIR1 on Wi-Fi the following steps need to be taken.
NOTE: Default IP address for the VSX-1.3MP-PIR1 camera is: 192.0.0.6
1 - Connect the VSX-1.3MP-PIR1 camera via the NIC interface directly to the NVR,
programming laptop or network switch.
2 - Using the VSX IP Setup Utility you can now change the IP address of the camera.
This can also be performed in the camera user interface.

Quick Reference Guide
Page 3
5 - Login to the camera's user interface by clicking on the Web Settings button ().
NOTE: The default user: admin with password: 12345.


Quick Reference Guide
Page 4
6 - Click the Advanced Configuration button (), then click the Network button (),
then click the TCP/IP button ().
7 - Select wlan from the Select NIC drop down list (). Assign your IP address.





Quick Reference Guide
Page 5
8 - Click the Wi-Fi tab () and find your wireless SSID.
9 - Enter the Security Mode () and Encryption Type ().
10 - Enter your wireless network security key ().
11 - The camera can now be disconnected from the programming PC\NVR
12 - Set up the appropriate IP scheme in the NVR (if changed for programming).
13 - Now configure your NVR for this camera.




Quick Reference Guide
Page 6
The VSX-2MP-PIR1 is now configured and accessible as one of the Cameras () currently
installed on your network.
