7RYMS RimoMic Lite UC User manual
Foreword
Main Features
Thanks for purchasing 7RYMS RimoMic Lite UC Mini Wireless Microphone
(For USB-C & USB-A Interface )
To ensure bring you a good using experience, please read this manual book
carefully before using and correctly install and operate.
. Mini Wireless Microphone, Delicate and Portable
. Wireless Working Range up to 30m
. Support Real-time Monitor for Both PC&MIC
. Intuitive Visual Power and Volume Monitor
. Adjustable Volume, Low Cut Filter
. Auto Pair & IR Sync, Efficient and Convenient
. Built-in Rechargeable Lithium Battery, USB-C Charging Port
Notice
Please make sure the IR sensor are closely aligned when pairing
This product belongs to high-precision instruments, please avoid falling,
collision or pounding
Do not use this equipment in the vicinity of heat source or interference
source, such as radiator, oven, refrigerator or air conditioner, smartphone
or next to the WIFI AP
If the pick-up distance is close or when used outdoors, please put on the
wind muff to prevent sound burst or reduce wind noise
Do not use the equipment in rain or in a damp environment to avoid
short-circuit danger
Please keep the product in a dry environment
1
Packing List
Receiver (RX)Transmitter(TX)
Main Parts:
1. USB C-USB A Adapter
2. Wind Muff
3. Charging Cable
4. Carry Case
5. User Manual
6. Warranty Card
Accessories:
Vendor:
VendorTel:
Dateof Purchase:
CustomerName:
Address:
EmailAddress:
Tel:
WARRANTYCARD
www.7ryms-audio.com
Errun Electronic Technology
ProductModel:
Vendor'sinformation Customerinformation
Vendor'sSignature:
ProductSN:
User manual
Streamingand Video Mini Wireless Microphone
(ForUSB-C & USB-A Interface)
① ② ③ ④ ⑤ ⑥
2
Transmitter(TX):
Components Introduction
1. Internal Mic
2. Power/Low Cut Filter Indicator Light
3. Audio Status Indicator Light
4. Volume+
5. Volume
6. Power/Low Cut Filter Button
7. Belt Clip
8. IR Sensor
9. USB-C Charging Port
-
①
④
⑤
⑥⑧
⑨
⑦
②
③
3
Receiver (RX):
1. IPS Display Screen
2. USB-C Plug
3. IR Sensor
4. Pairing Button
5. 3.5mmTRS/TRRS Monitor Interface
②
①
⑤
③
④
4
Transmitter(TX):
Installation and Operation
Belt Clip
Install the transmitter on the collar through the belt clip so that the
internal microphone points in the direction of the sound source
Internal Mic
For better hiding during use, it is recommended that the
belt clip be fixed and used outwards 5
Receiver (RX):
Install the receiver to the mobile phone with USB-C interface
through the USB-C plug.
1. Work with Smartphone:
6
2.1 For computer with USB-C port, insert the receiver into the
computer USB-C port;
2.2 For computer with USB-A port, insert the receiver into the
USB C-USB A adapter; Then insert the USB C-USB A
adapter into the computer USB-A port
2. Work with Computer:
USB C-USB A Adapter
7
IR
(TX)
(RX)
IR
After installing the receiver on the smartphone or computer,
keep the receiver and transmitter's IR sensor closely aligned for
paring
3. Pairing:
8
Function and Usage
Point the internal Mic at the sound source to record
1. Internal Mic
Transmitter (TX):
Short press to adjust the microphone’s volume
4. Volume+ Volume-
Blue light keeps on after turn on the Transmitter; Purple light
keeps on after turn on Low Cut Filter mode; Red light flicker
when pairing or low power; Red light keeps on when charging
2. Power/Low Cut Filter Indicator Light
Blue light flicker when sound is input; Red light keeps on when
sound is crackled
3. Audio Status Indicator Light
Long press to turn on/off; short press to switch low cut
5. Power/Low Cut Filter Button
9
Connect the transmitter and 5V power supply through the USB
A-USB C charging cable for charging
6. USB-C Charging Port
It's paired successfully only when the receiver and transmitter's
IR sensor are closely aligned
7. IR Sensor
10
It's paired successfully only when the receiver and transmitter's
IR sensor are closely aligned
1. IR Sensor
Receiver (RX):
Long press to pair
2. Pairing Button
Insert 3.5mm TRS/TRRS headphones to monitor
3. 3.5mm TRS/TRRS Headphone Monitor Port
11
56
VOL
Screen Display Instruction:
Transmitter Battery StatusSignal Strength
Volume
Audio Dynamic Bar
Current Channel
12
56
VOL
32
VOL
In the Pairing After pairing, the new channel will be displayed
13
25
This device operates on a no-interference, no-protection basis. Should the user seek to obtain
protection from other radio services operating in the same TV bands, a radio licence is required. For
further details, consult Innovation, Science and Economic Development Canada's Client Procedures
Circular CPC-2-1-28, Voluntary Licensing of Licence-Exempt Wireless Microphones in the TV Bands.
Email: [email protected]
The 7RYMS LOGO is trademark which is registered and owned by
Errun Electronic Technology Co., Ltd
www.7ryms.com
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
ISED Statement
‐English: This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference, including interference that may cause
undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B).
‐French: Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes: (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encompromettre le
fonctionnement.
l'appareil numérique du ciem conforme canadien peut ‐3 (b) / nmb ‐3 (b).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure
and compliance.
cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du
cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des
données canadiennes sur l'exposition aux champs rf et la conformité.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Cet équipement est conforme Canada limites d'exposition aux radiations dans un environnement
non contrôlé. Cet équipement doit être installé et utilisé à distance minimum de 20cm entre le
radiateur et votre corps.
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure
and compliance.
cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du
cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des
données canadiennes sur l'exposition aux champs rf et la conformité.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 0mm
between the radiator & your body.
Cet équipement est conforme Canada limites d'exposition aux radiations dans un environnement
non contrôlé. Cet équipement doit être installé et utilisé à distance minimum de 0mm entre le
radiateur et votre corps.
For Receiver:
For Transmitter:
Table of contents
Other 7RYMS Microphone manuals
