Access Lighting SQUARE 20399LEDMG User manual

IMPORTANT
Before assembling your ACCESS LIGHTING fixture, please make sure that
you carefully read through these instruction sheets. Consider having
your fixture installed by a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
PREPARE FIXTURE AND CONNECT THE WIRES
If there is an existing fixture remove it. Gently pull the supply
wires out of the J-box.
Mount the crossbar to the J-box with
the supplied screws.
Connect the black supply wire to the
black fixture wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white fixture wire.
Secure with the supplied wire nuts. Either wrap the green
wire around one of the protruding screws or connect it to the
supply ground wire. Secure all wires with U.L. Certified
electrical tape (not supplied). Tuck all wires carefully into
the J-Box.
1
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
WHAT YOU NEED
• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
INSTALLATION INSTRUCTIONS
WHAT WE PROVIDE
•
Crossbar
• Mounting Hardware
• LED
COLLECTION
1
CERTIFICATION: ETL WET NO. 20399LEDMG
20399LEDMG
APPLICATION MODEL NO.
Wall FixtureSQUARE

2
4
2
CERTIFICATION: ETL WET NO. 20399LEDMG
3
MOUNT THE BACKPLATE
Fit the backplate up to the crossbar.
Align the holes of backplate and secure with
the supplied screw nuts.
MOUNT THE FIXTURE AND COVER THE SHADE
Align the fixture holes with the backplate screw and
secure with the supplied screw knobs (with screw gaskets)
Slide the cover shade into its designated slot from the top.
* This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Indoor/Outdoor Silicon Sealant be used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION