Accu-Scope EXC-400 Series Owner's manual

73 Mall Drive • Commack, NY 11725 • www.accu-scope.com • Phone [phone] • Fax [phone]
EXC-400 Microscope Series
SUPPLEMENTAL INSTRUCTIONS
Dual-View Front-to-Back Quick Assembly Diagram
Set up the Main Microscope -- EXCEPT for the Main Viewing Head and Eyepieces -- following the
instructions in the EXC-400 Microscope Series Manual. The Main Viewing Head and Eyepieces will be
mounted after the Front-to-Back LED pointer unit is mounted.
1 LED pointer unit
2 Main Viewing Head & Eyepieces
3 Secondary Viewing Head & Eyepieces
1
2
3

73 Mall Drive • Commack, NY 11725 • www.accu-scope.com • Phone [phone] • Fax [phone]
EXC-400 Microscope Series
SUPPLEMENTAL INSTRUCTIONS
Dual-View Front-to-Back Detailed Set Up
Set-up on a sturdy, level surface with a minimum space requirement of 30(d) x 20(w) inches for the
front-to-back orientation.
Assemble the Main Microscope –Figure 1
1. Set up the Main Microscope -- EXCEPT for the Main Viewing Head and Eyepieces -- following the
instructions in the EXC-400 Microscope Series Manual. The Main Viewing Head and Eyepieces
will be mounted after the LED Pointer Unit is mounted.
The assembly of the main microscope includes the objectives, lamp house and the
stage/condenser assembly.
2. Mount the LED pointer unit to the top of the main microscope frame.
3. Mount the Main Microscope Viewing Head on the top of the LED Pointer Unit, then install the
eyepieces.
4. Install the Secondary Viewing Head onto the top of the Secondary Viewing Head Assembly, then
install the eyepieces.
Figure 1
Main Viewing Head
LED Pointer Unit
Secondary Viewing
Head
Main Microscope Frame

Operation
Dual Observer Arrangement
(The ABC is the direction of image observed in the eyepieces)
Two Observers, Front-to-Back Orientation
Adjust the Pointer Brightness
NOTE: If the pointer is not in the field of view, rotate the pointer controller to move the pointer to the center of
the field of view.
The pointer is optimally used during observation of dim specimens. When the specimen is bright, it may be
difficult to see the pointer even when the light adjustment knob for the pointer is turned up.
The pointer light adjustment knob is used to adjust the brightness of the pointer. Rotate the pointer light
adjustment knob clockwise to increase the brightness; counterclockwise to decrease the brightness.
To turn off the pointer, rotate the pointer light adjustment knob counterclockwise until it stops, then rotate it
slightly further to the off position.
Pointer Movement
The main head observer can move the pointer to the desired position by operating the pointer controller.
Pointer Light
Adjustment Knob
(on left side of
LED Pointer Unit)
Pointer
Controller
Main Head View
Second Head
View
ABC
ABC
Orientation of observed image: