ACF TRASH GUARD PLUS User manual

1. ATTACH PIANO HINGE TO TRASH
GUARD PLUS®
HARDWARE ASSEMBLY DETAIL
Secure piano hinges to rear of Trash Guard Plus® with 3 bolts and 3 nuts as
shown. .
ATTACHING TRASH GUARD PLUS® TO ROUND BASIN WALL
3. ATTACH CAP ROUND PANEL TO TRASH GUARD PLUS®
Place two spacers on top of Trash Guard Plus® top. Place Cap Round Cover
over trash guard as shown below. Adjust spacers to align with slots in Cap
Round Cover as needed. With washers attached to screws, slide screws
through slots in Cap Round Cover and through holes in spacer. Torque
screws to penetrate surface of Trash Guard Plus® top.
Drill 2 inch deep
holes into Basin
Wall.
Insert plastic
anchors in
pre-drilled holes
Secure to wall with
6 screws and
washers
2. ATTACH TRASH GUARD
PLUS® TO BASIN WALL
FIGURE A
Adjust Cap Round Cover as needed to fit flush
with curved wall of Basin Wall.
When Cap Round Cover is flush against wall,
tighten screws to hold in place. Cap Round
Cover should be parallel to top of Trash Guard
Plus® and flush against Basin Wall as shown in
Figure A below.
Screw
Washer
Spacer
Cap Round Cover
Trash Guard Plus®
Piano
Hinge

Place two side mesh panels
on wall to mark and drill
2 in deep wall assembly holes.
Insert 6 plastic anchors into drilled holes and secure mesh to wall as
shown with 6 washers and 6 screws. (3 each per side mesh panels)
Position Trash Guard Plus in place
and slide steel rods through holes in
Trash Guard Plus® to mark assembly
position on wall with chalk as shown.
Drill 1/2 inch deep pilot holes into wall at marked areas
perpendicular to wall.
Rotate drill as shown to run perpindidular to Trash Guard Plus
and drill 2 inch deep holes into wall for rod assembly hardware. Insert metal anchors into wall.
Thread rods into anchors and attach 2 washers
and 2 nuts onto rod as shown below.
Adjust hardware as shown below to tighten rod to
wall and allow placement of Trash Guard Plus to
rod.
Slide Trash Guard Plus into place on rods.
With Trash Guard Plus in place, attach side mesh panels to side of Trash Guard Plus with 4 tie wraps and 6 washers and 6 nuts as shown.
TIE WRAPS
TIE WRAPS
WASHERS
AND NUTS
ATTACHING SIDE MESH PANELS TO WALL AND TRASH GUARD PLUS® IN
ROUND BASIN