ACTi VMGB-351 User manual

VMGB-351
Installation Guide
2020/05/11

www.acti.com
Installation Guide
2
Thank you for purchasing ACTi products and solutions. The following documentation covers
basic installation instructions of your device.
NOTE: The accuracy of the analytics algorithm may be affected by different environmental
factors or inappropriate installation. Please follow the procedures in this guide. ACTi will
not be liable for inaccuracies resulting from the aforesaid causes.
Installation Height
The accuracy of your device greatly depends on the camera installation. The recommended
installation parameters are as follows:
Installation Height: 4 ~ 6 meters
Tilt angle: 15° ~ 30°



Detection Range Table
The maximum video content analytics (VCA) range varies depending on events. The key point is
to take the object (human / vehicle) distance into consideration. The maximum range is as below:
VCA Range
(Vehicles:1.4*4.0m)
VCA Range
(Humans:1.4*4.0m)
Temperature
Measurement
(Object:2*2m)
Temperature
Measurement
(Object:1*1m)
126m
42m
132m
66m
NOTE:
Different targets trigger analytics events within different range limits.
The above table is for reference only; the performance may vary depending on
different environmental factors and installation.

www.acti.com
Installation Guide
3
How to Connect Digital Input / Output Devices
Digital Output or Alarm Output
The internal device is equivalent to a switch, no polarity
Maximum Load Current is 1A, Maximum Battery Voltage is D30V or AC24V
A, B completely hung up, no connection to the earth.
Digital Input or Alarm Input
Short circuit the Alarm In and GND to trigger the alarm.

Copyright © 2019, ACTi Corporation All Rights Reserved
7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu District, Taipei, Taiwan 114, R.O.C.
TEL : [phone] FAX : [phone]
Email: [e-mail]