Action S002102 User manual

6 Station Swing Set
S002102
Instruction Manual
WARNING : To ensure your safety, please do not attempt to assemble this swing set without reading this
instruction manual carefully. Failure to comply with this warning may result in injury and/or property damage.
Prior to assembly, this swing set includes small parts/accessories that are not suitable for children under 3 years
of age as they may cause a choking hazard.
This swing set should be assembled by 2 adults.
Only use this swing set on a soft,
level surface.
This swing set has a maximum user weight of 34kg per unit/seat. Only one child per seat at any time.
The total weight on the swing set at any time must not exceed 204kg.
This swing set is suitable for users aged 3-9 years.
This swing set is designed for outdoor domestic use only, it is not intended for commercial use in play centres,
nurseries etc.
For parts and service enquiries, please contact Action Spares on 1800 465 070 or e-mail [email protected]
flat,

2S002102 6 Station Swing Set
Contents
3 Important Safety Information
5 Swing Parts List
6 Hardware List
7 Assembly Instructions
15 Warranty

3S002102 6 Station Swing Set
Important Safety Information
To reduce the risk of serious injury, read the entire manual before you assemble or use
this swing set. In particular, please note the following safety precautions. Please keep
this manual in a safe place for future reference. Failure to assemble and maintain this
product correctly may cause injury to the user.
1. Regularly check the swing set for wear and damage, replace any worn or damaged
parts immediately. Remove the swing set from use until replacement parts are
Check all hardware regularly and tighten when required.
2. Check swing seats, ropes and any other means of attachment for evidence of
deterioration prior to each use.
3. Prior to assembly, this swing set includes small parts/accessories that are not
suitable for children under 3 years of age as they may cause a choking hazard.
4. Do not overtighten the nuts and bolts. Use hand tools only, do not use power tools
as this can weaken the connection points.
5. This swing set should be assembled by 2 adults.
6. This swing set is designed for use by children 3-9 years of age.
7. This swing set is designed for domestic use only, it is not intended for commercial
use in play centres, nurseries, etc.
8. This swing set has a maximum user weightof 34kg per unit, totalling 204kg across
the entirety of the swing set.
9. Do not install this product over concrete, asphalt or any other hard surface.
10. Do not orientate the swing set directly towards the sun.
11. There should be at least 2m of space surrounding the swing set from any structure
of obstruction such as a fence, garage, house, wall, overhanging branches, laundry
lines, electrical wires, etc.
12. Swings must not exceed an angle of 60 degrees from the ground.

4S002102 6 Station Swing Set
Warnings (cont)
13. The knots in the swings are integral to the safety of the swing set. Please ensure
they are tight and that the swing is in the correct position, there should be no slack
in the rope allowing a loop to form below the swing.
14. The minimum distance between any swing and the ground is 350mm.
15. This swing set must be anchored into the ground using the included anchor
pegs.
16. Do not allow additional foreign objects to be attached or used with the swing set.
17. Children must be supervised by an adult at all times while using the swing set.
18. Only 1 child should use each swing (unless designed for 2 children) or
slide at any time.
19. Do not use the swing set when it is wet as it will become slippery and serious injury
may result.
20. Do not stand on the seats when using the swing set.
21. Do not climb on or jump from the swing set when it is in motion.
22. Do not climb or hang on the frame of the swing set.
23. oD not walk close to, in front of or behind the swing set when in use as moving
units can cause serious injury.
24. Do not wear apparel such as hats with straps, helmets, scarves, garments with pull
strings or any other item of loose clothing while using the swing set as children can
get trapped and may be unable to free themselves causing serious injury.
25. Do not twist swing ropes or wrap them over the top bar.
26. Do not slide head down the slide, walk up the slide or jump/climb off the slide.

5S002102 6 Station Swing Set
Swing Parts List
Leg (x3)
Clamps (x2)
Leg (x1)
Netball Ring (x1)
Nest Swing Fabric (x1)
Nest Swing Rope (x2)
Nest Swing Metal Frame
With Foam Padding (x4)
21
41
43
Short Bracket (x4)
(x2)
33
20
(x1)
Top Leg (x2)
48
1
3
4
6
8
14
2
9
10
11
18
7
47
13
Ground Peg A( X 6)
24
Lower Support Tube (x2)
Upper Support Tube (x2)
Upper Slide (x1) Lower Slide (x1)
35 34
30

6S002102 6 Station Swing Set
Hardware List
M8 Bolt 62mm (x4)
F1
M8 Bolt 53mm (x6)
F2
M8 Bolt 59mm (x4)
F3
M6 Bolt 49mm (x7)
F4
M6 Bolt 47mm (x2)
F5
M8 Bolt 42mm (x2)
F6
M8 Bolt 82mm (x2)
F7
M6 Bolt 38mm (x8)
F8
Thin Plastic Spacer (x4)
Thick Plastic Spacer (x4)
M6 Bolt 62mm (x2)
C1
M6 Bolt 58mm (x2)
C2
M6 Bolt 32mm (x2)
C3
M6 Bolt 40mm (x2)
C4
M6 Bolt 60mm (x2)
C5
2
1 9
51 5150 50
721
46
8
10
12
3
11
4
16
13
43
3
6
19
32
28
33
25
20
6
18
M6 Bolt 20mm (x6)
C6
M6 Bolt 35mm (x8)
C7
M6 Bolt 66mm (x2)
C8
M6 Bolt 17mm (x3)
C9
M6 Bolt 66mm (x2)
D9

7S002102 6 Station Swing Set
Assembly Instructions
Step 1
Frame, Swing, Trapeze & Netball Ring Assembly
Note: Attach the swing rope to the U-bolt (S1) before connecting the U-bolt (S1)
to the top bar. Ensure that at least 3 threads from M8 U-bolt (S1) protude from the
top.
9
F3
F3
18
3
11 11
33
11
22
189
S1
F3
F3
4
51
4
F1 4
F1
Nest Swing Swing Set Trapeze

8S002102 6 Station Swing Set
Assembly Instructions (cont)
Position 1 Position 2
Warning: The knots on the swings are integral to the safety of the swing Please
ensure thet are tight and that the swing is in POSITION 1 as shown in the diagram
above. There should be no slack in the rope allowing a loop to form below the
swing.
Correct Assembly Incorrect Assembly
3
or
18
64
F4
3
6
212
46
51
951150
3
6
18 13 16
43
11
4
50
By using Bolt F4 to connect
the Leg (3,18) with the Side
Bars (6)
11
4
F4
By using Bolt F4 to connect
the Leg (11) with the Side
Bars (4)
8
10
12
7

9S002102 6 Station Swing Set
Assembly Instructions (cont)
Nest Swing Assembly
Insert the Metal Tube (41) into the fabric of the Nest Swing (13). Join the metal tubes together and
then fasten them by using the bolt at the end of the Rope (43). (See above).
Repeat this for the other side, and then the Nest Swing becomes two semicircles (See below).
Lay the two semicircles on the ground,
join the two part tubes together, and
then press it down so that two parts are
joined together as a circle.
Press Press
PressPress
Semicircle
Semicircle
Finished
43
41
41
41
43
43
Step 2
13
13
13

10 S002102 6 Station Swing Set
Assembly Instructions (cont)
8
10
G9
F7
F8
12
11
(34)
(34)
35
C6
C6
Step 4
Slide Assembly
Step 3
Glider Assembly
F5
F6

11 S002102 6 Station Swing Set
Assembly Instructions (cont)
The M6 Bolt 35mm (C7) for Support Strap (29 & 31 & 30)
only need to be finger tight.
Top of slide
C7
C7
C7
C7
C7
C7
C7
C7
C8
C9
C9
C9
C9
29
30
30
Bracket Assembly
Assembly of the Bracket onto the Slide

12 S002102 6 Station Swing Set
Assembly Instructions (cont)
Step 5
Slide Assembly continued
on the rear of Leg (18).
28
19
18
33
25
20
25
32
33
C3
F4
28
D9

13 S002102 6 Station Swing Set
Assembly Instructions (cont)
Please do not overtighten nuts and bolts. Use hand tools only. Do not use power tools. This can
weaken the connection points.
Please ensure that Top Ladder Rung (19) is tted behind both Ladder Handles (28)
and on the
rear of the Leg (18).
Please see the below image for correct assembly.
Please note that the Top Ladder Rung (19) is behind the
Ladder Handles (28) supporting the slide.
Please note that the Top Ladder Rung (19) is in front of
the Ladder Handles (28) and not supporting the slide.
Please assemble Chute Side Stay Bar (20) last. Leave the bolts loose until the slide is assembled to the
ladder frame, to make construction easier. Then tighten
Correct Assembly
Incorrect Assembly
28
28
30
C1
D9
C2

14 S002102 6 Station Swing Set
Assembly Instructions (cont)
Step 6
Anchoring the Swing Set to the ground
Important: For safety reasons this swing set MUST be anchored into the ground.
To carry out this procedure, you must hammer the included pegs into the ground
Attach the swing to the pegs at the connection points shown below. We highly
recommend these anchor pegs be concreted, but this is optional. However if
the ground is soft and the peg can easily be pulled out by hand once installed,
concreting is essential. Contact our service centre for more information.
Once assembly is completed, carefully check equipment. In the unlikely event that you do any
problems, please contact us. DO NOT allow children to use this product until the problem has been
corrected.
48
48
311
47
47

15 S002102 6 Station Swing Set
Warranty Information
Congratulations on your purchase!
This Action 6 Station Swing Set is warranted to be free from defects in material and workmanship
under normal use and service conditions for a period of 12 months from the date of purchase of this
article. Evidence of unfair usage or incorrect adjustment by the owner will void this promise.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure.
The conferred by this warranty are in addition to the consumer guarantees and other rights
and remedies in respect of the product which the consumer has under the Australian Consumer law.
Conditions of Warranty
All warranty coverage extends only to the original retail purchaser from the date of purchase. Please
keep your receipt, tax invoice or other proof of purchase.
This warranty does not extend to any damage to a product caused by abuse, improper or abnormal
usage, or repairs not provided by us or our Service Centre. Nor does this warranty extend to products
used for commercial or rental purposes. This warranty does not cover ordinary wear, tear and
weathering, failure to follow directions, improper installation, improper maintenance or acts of God
(such as damage caused by storms, lightning, heavy winds and by snow or ice).
Making A Warranty Claim
In order to make a claim under this warranty please direct your enquiries to our Service Centre. You can
contact them on our Freecall 1800 465 070 number or send mail to them at National Service Centre:
2/24 Anderson Road, Smeaton Grange, NSW 2567 – if mailing please include your contact details.
A service representative will then assist you in the appropriate action to be taken. For
processing of your enquiry please have proof of purchase, the date of purchase and the retailer name
you purchased the item from, and the brand on the product. Photos of the product, and scans of
receipts, may be requested to assist with your claim.

16 S002102 6 Station Swing Set
Warranty Information (cont)
The service centre representative will assess the claim. If:
1) There is a minor fault, they can offer either a replacement spare part, replacement unit, repair or
other suitable remedy.
2) There is a major fault, they can offer a replacement, repair or suggest you return to the store you
purchased it from for a full refund.
Please note: a request for compensation will need documentary evidence of the loss or damage
suffered. It will also need to be evidenced that such a loss was a reasonably foreseeable result of
a failure to comply with a consumer guarantee under the Australian Consumer Law.
3) The product was damaged through abnormal use, no refund or repair can be offered.
The sending of replacements, spare parts or the cost of repair carried out will be organised and
covered by the Service Centre. If collection of the item is required this will be organised by the Service
Centre and at our expense. Do not return any products without authorisation as this will be at your
expense.
Our sales and service centre has been set up to provide assembly assistance, replacement parts and
accessories, and to handle all warranty related matters. Please note upon receiving your
warranty claim our Service Centre will send, via post or email, a repair and refurbished goods or parts
notice.
SERVICE CENTRE
Contact details and hours of operation.
Freecall 1800 465 070
9:00am – 4:30pm Monday to Friday (excluding Public Holidays)
9:00am – 3:00pm Saturday
This product is warranted and distributed by:
Action Sports of 48B Egerton St, Silverwater NSW, 2128
Phone: [phone]
© 2017 Action Sports Equipment Pty Ltd.