ACTiSYS IR8200P User manual

I
Ir rD DA A®
®
C Co om mp pl li ia an nt t P Pr ro ot to oc co ol l P Pr ro oc ce es ss so or r
921 Corporate Way, CA 94539
Tel: [phone], Fax: [phone]
E-mail: [email protected], http://www.actisys.com
A
A
A
C
C
C
T
T
T
-
-
-I
I
IR
R
R
8
8
8
2
2
2
0
0
00
0
0P
P
P
/
/
/
P
P
P
M
M
M
¾A complete IrDA® Protocol stack in a single chip.
¾Includes IrPHYTM encoding/decoding and interfaces directly to Infrared transceivers
for data rate up to 115.2 kbps. Only an external Infrared transceiver is needed to
complete an IrDA compliant infrared communication subsystem.
¾Off-the-shelf, semi-custom, or full-custom firmware in on-chip Flash EPROM.
¾Supports both IrDA Primary and Secondary mode.
¾Supports host baud rate from 9.6 kbps to 115.2 kbps.
¾Low supply voltage, 3.0 V to 3.6 V.
¾Low current consumption, 2μA standby, 3mA active.
¾Small low profile plastic 64-pin QFP package.
¾Choice of different amount of on-chip RAM and Flash EPROM to optimize cost and
performance.
¾Available in programmed and tested chips, assembled & tested boards, or fully
packaged devices.
¾Abundant uncommitted on-chip resources can be utilized to implement a small
complete embedded system by itself without a host CPU.
¾A ready-made IrDA-compatible CMOS board and RS232 dongle for SCI interface are
available: UART board: ACT-IR100Spi ; RS232 dongle: ACT-IR100SP
¾A very useful Evaluation Kit Full Set is ACT-IR8200PEKK, which is: ACT-IR8200PEK
+ ACT-IR4000US (notebook/desktop USB-IrDA adapter). This is to test
ACT-IR8200P with ACT-IR4000US in the earlier developing stage to avoid debugging
multiple issues at the same time.
All trademarks, logos, organization & company names, and product model names are owned by the
respective organizations or companies