ADA INSTRUMENTS GroundDrill - 12 User manual
Operating manual
Ground drill
Model: GroundDrill - 12
Manufacturer Address: WWW. ADAINSTRUMENTS.COM
GroundDrill - 12
1. Introduction .......................................................................................................................................................................................3
2. Precautions..........................................................................................................................................................................................3
3. Features...............................................................................................................................................................................................5
7. Stopping..............................................................................................................................................................................................9
Appendix 1.
Appendix 2.
Table of contents
- 12
MEASUREMENT FOUNDATION
GroundDrill - 12- 12
3
1. Introduction
-
2. Precautions
MEASUREMENT FOUNDATION
GroundDrill - 12
4
when operating.
to cool down.
- 12
MEASUREMENT FOUNDATION
GroundDrill - 12- 12
5
1. Engine
2. Handle
4. Reduction gear
5. Drill
2. Fuel line
3. Check button
4. Fuel tank
5. Fuel tank cap
starter line
7. Spark plug
12. Case cap
14. Crank case of the engine
17. Starter handle
3. Features
MEASUREMENT FOUNDATION
GroundDrill - 12
5. Preparation before operation
Match power shaft of the reduction gear and drill shank. Place power shaft into the shank. Fix the connection with the bolt.
- 12
MEASUREMENT FOUNDATION
GroundDrill - 12- 12
7
plug.
2. Check the air intake and outlet for clogging.
burn excess fuel.
5. Check the spark plug for spark.
Caution
Note
-
Note:
30
10W-30
5W-30
dipstick
upper oil level
low oil level
MEASUREMENT FOUNDATION
GroundDrill - 12
6. Operation
Important!
all internal parts.
1. Stop
2. Idling
3. Fast
- 12
MEASUREMENT FOUNDATION
GroundDrill - 12- 12
9
7. Stopping
1. Release throttle to idle speed.
Note:
8. Daily maintenance
Note:
or 5 Hrs.
or 25 Hrs.
or 50 Hrs.
check *
change *
check *
clean * * *
Spark plug check - clean *
clean *
Fuel line check
MEASUREMENT FOUNDATION
GroundDrill - 12
10
Note:
Caution
- 12
MEASUREMENT FOUNDATION
11
GroundDrill - 12- 12
Caution
FILTER
AIR CLEANER
BODY
FILTER,
OUTER
LATCH
TABS
AIR CLEANER
COVER
CAP NUT
FILTER
MEASUREMENT FOUNDATION
12
GroundDrill - 12
Caution
Caution
2. Inspect the spark plug.
-
Note
after the spark plug seats.
Caution
9. Long term storage
2. Run engine until it runs out of fuel.
- 12
MEASUREMENT FOUNDATION
GroundDrill - 12- 12
13
Warranty
Exceptions from responsibility
-
ing with other products.
WARRANTY DOESN’T EXTEND TO FOLLOWING CASES:
-
instruction.
-
WARRANTY CARD
Name and model of the product ________________________________________________
Serial number ________________date of sale_______________________
Name of commercial organization _____________________stamp of commercial organization
Warranty period for the instrument explotation is 24 months after the date of original retail purchase. It extends to the equipment, imported
During this warranty period the owner of the product has the right for free repair of his instrument in case of manufacturing defects.
occur in the result of the instrument outage.
The product is received in the state of operability, without any visible damages, in full completeness. It is tested in my presence. I have no
complaints to the product quality. I am familiar with the conditions of qarranty service and i agree.
purchaser signature _______________________________
Before operating you should read service instruction!
If you have any questions about the warranty service and technical support contact seller of this product
__________________________________________________________________________
__________________________________________________________________________
name and model of the instrument
Corresponds to ______________________________________________________________
designation of standard and technical requirements
Data of issue _______________________________________________________________
Stamp of quality control department
Price
Sold ___________________________________ Date of sale ______________________
name of commercial establishment
GroundDrill - 12
- 12
MEASUREMENT FOUNDATION
19
GroundDrill - 12- 12
MEASUREMENT FOUNDATION
GroundDrill - 12
Table of contents
Other ADA INSTRUMENTS Drill manuals
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill-9 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill 5 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill-2 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill - 14 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill - 1 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill-9 User manual
ADA INSTRUMENTS
ADA INSTRUMENTS GroundDrill - 8 User manual
