ADCO EasyCut 5000 User manual

Safe Cutting
Instructions
5000/6000
11333 Pagemill Road
Dallas, TX 75243
Toll Free: 800-527-4609

Features
BLADE RELEASE
BUTTON
TRIGGER
TRIGGER
LOCK
5000/6000
BLADE
SLOT

Removing the blade:
CAUTION: BLADES ARE SHARP, TAKE
PROPER CARE WHEN HANDLING.
Engage the trigger lock and squeeze the
trigger to expose blade. (Fig 1)
Using your index finger, press the blade
release button and hold while you are
removing the old blade. (Fig 2)
Dispose of blade properly. Do Not Discard
in Trash!
RELEASE TRIGGER
LOCK AND
PULL TRIGGER
PRESS BLADE
RELEASE BUTTON
REMOVE BLADE
Installing the blade:
Engage the trigger lock and squeeze the
trigger. (Fig 1)
Do not press blade release button during this
procedure.
Slide a new blade into the slot until you hear
an audible click. (Fig 2)
Confirm proper installation be extending the
blade and pulling slightly on the blade to
confirm it is locked into position
INSERT BLADE
INTO BLADE SLOT
UNTIL IT CLICKS
RELEASE TRIGGER
LOCK AND
PULL TRIGGER
TEST BY PULLING
ON THE BLADE
Figure 1
Figure 2 Figure 3
Figure 1
Figure 2
Figure 3

How to hold your Easy Cut Cutter
Hold the cutter at the front with your thumb and forefinger, with your thumb running
parallel with the body of the cutter. Your forefinger is on a 90 degree angle with
the body of the cutter covering the opposite side. All of the pressure to hold the
cutter is at this point. The remaining three fingers wrap gently around the trigger.
The focus is on the pinky finger. You should engage the blade by squeezing the
trigger with the pinky finger. The other two fingers can lay gently on the trigger.
Squeeze the trigger with the pinky finger with the other two fingers lying
gently on the trigger.
LEFT HAND
RIGHT HAND

Cutting Posture:
IMPORTANT: Always center cut on your body for most types of cuts. When holding the
box, place your opposite hand away from the cutting area and use it to support the box you
are cutting. (Fig 1)
This is the safest method for tape cuts, top cuts, window cuts and tray cuts.
ALWAYS
CENTER
THE CUT
ON BODY
Figure 1

Starting a few inches from the uppermost section of stretch wrap, pull the blade downward through
the stretch wrap (fig 1). When you get to the bottom, return to the top and finish the last few inches.
The purpose of the stretch wrap remaining at the top is that it holds tension on the stretch wrap
till you get it cut all the way to the bottom (Fig 2).
Stretch Wrap
IMPORTANT: Cut both taped ends as shown (Fig 1,2). Using your index finger, lift up the end and
hold tension away from the merchandise while cutting down the center of the box. (Fig 3)
Tape Cut
ALWAYS
CENTER
THE CUT
ON BODY
Figure 1 Figure 2
Figure 3
Figure 1 Figure 2

©2015 ADCO Industries