ADDAC System ADDAC217 User manual

July.2020
ADDAC217 Assembly Guide
ADDAC SYSTEM page 2

ADDAC SYSTEM page 3
ADDAC217 Assembly Guide
STEP 1:
Start by locating the 2 capacitors, notice the orientation printed on the pcb.
Tip: soldering these caps is easy, just place a dab of solder on the pad on your right (left pad if you’re
left handed) and then, with the help of a tweezer, put the capacitor in place and reflow the previously
tinned pad to melt the solder while pushing the capacitor down. Then solder the other pad.
Follow up by locating and soldering the 78L05 Voltage Regulator, notice the orientation printed on the
pcb. After soldering trim the excess legs.

ADDAC SYSTEM page 4
STEP 2:
Next carefully break the 2 pcbs apart and proceed to locate the male and female pinheaders and solder
them like shown below.
STEP 3:
Next locate and solder the IDC Connector, notice the orientation printed on the pcb..
ADDAC217 Assembly Guide

ADDAC SYSTEM
STEP 4:
Next place all parts of the pcb and follow up by placing the frontpanel and tighten the nuts.
After everything is in place proceed by soldering all pads.
page 5
ADDAC217 Assembly Guide

ADDAC SYSTEM
STEP 5:
Finish by attaching both boards together.
page 6
ADDAC217 Assembly Guide

ADDAC SYSTEM page 7
Congratulations you’re done!
Happy Patching!
ADDAC217 Assembly Guide

For feedback, comments or problems please contact us at:
[email protected]
ADDAC217 ASSEMBLY GUIDE
July.2020Revision.01