Addonics Technologies SU3CS User manual

Technical Support
If you need any assistance to get your unit functioning properly, please have
your product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
Email: http://www.addonics.com/support/query/
www.addonics.com
T E C H N O L O G I E S
Sapphire USB 3.0 / eSATA Drive Enclosure
(SU3CS)
User Guide

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
1
Unpacking and Overview
SU3CS
Front View
Back View
Inside View 2
4
31
2
3
4
1. On/Off Switch
2. Cooling Fan
3. Power Connector
4. USB 3.0 Port
1. 4P Molex Power Connector
2.
SATA-USB 3.0 Bridge
3. SATA Device Connector
4. Power Board
Mounting Holes

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: [phone] Email: www.addonics.com/support/query/
eSATA cable USB Cable
Power Cable
1. Loosen the two cover screws on the back of the unit found on the left and
right edges. Remove the rear cover, then slide the top cover off.
2. Remove the front plate and replace with a 5.25" drive, or a 2.5" or 3.5"
device mounted in a 5.25" mounting bracket using the 5.25" drive
mounting holes.
3. Reassemble the unit.
4. Connect the power supply from an AC outlet to the back of the unit.
5. Connect an eSATA or USB host to the unit and turn it on.
NOTE: When connecting the unit to a host using USB, there must be no cable connected to the
eSATA port on the back of the unit.
Installation

www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
CONTACT US