Advantech UCAM-120 User manual

Automatic
Sliding Door
Install device in the middle and keep a
20-60 cm distance from the door.
Rotation Door Install device in the middle and keep a
20-40cm distance from the door.
Push/Pull Inward
Opening Door
Install device in the middle and keep a
distance greater than the door width.
Install here
UCAM-120 Counting Camera
Quick Device Installation Guide V1.0
Pre-installation Guide
Supported Height of Installation 2.5m –5m
Supported Tile Angle -10°–10°
Front Side Reverse Side
Mount The Device
Recessed
Mounting
Use bundled recessed mounting bracket for mounting. Insert device with its signal light s facing the bracket
and grip it with two swiveling clamps.
Install Device On Site
Install one single device when the entrance width is not greater than 3.2m.
Single Device
Avoid Exist sign and
any obstacles like air
curtain.
Install here
Step1: Where to install the device?
Step2: How to Install?
Follow Step1 to
decide the best
position. Drill a
hole using a
hole saw.
Follow ‘Mount The
Device’ to mount TD
sensor into the
bracket and connect
Ethernet cable from
the reverse side.
Insert the
mounted device
into the hole
opened. Fix it
with screws with
front side
downward facing.
www.ushop-plus.com

If the entrance width is greater than 3.2m, more than one device are required. Follow the steps
of installing single device to install each device while paying special attention to the following.
Multiple Devices
Each device shall keep the same distance
from the door. As shown in the photo, three
devices keep the same 60cm distance from the
door.
Plan the distances between devices and their
distances from the wall before installation.
Entrance width: 6m
Quantity of devices: 2
Distance from the wall:
A: 1.5m; B: 1.5m from the other wall.
AB
Switch
POE Injector
UCAM-120
UCAM-120
Switch
POE Switch
Connect devices based on site situation and quantity of devices using either of three optional
networking structures.
For further information, please send to [email protected]
Constant red
light indicates
device error.
Constant orange light
indicates default factory
settings; flashing light
indicates server connecting
error.
Flashing green light
indicates device
connected to server,
working normally.
Example
Observe the signal lights after the device is installed and configured through its web interface.
UCAM-120 Counting Camera
Quick Device Installation Guide V1.0
Install Device on Site
Network Connection
POC Switch
UCAM-120
123
Signal Lights Indicators
www.ushop-plus.com