Adventure Kings A5 User manual

Heads Up Display (HUD)
USER MANUAL
Model: A5

1
Adventure Kings Heads Up Display
CONTENTS
1. Introduction to the HUD. ..............................................................3
2. Additional Information. ................................................................3
3. Unit Display & Switch Functions.................................................4
4. Menu Options. ..............................................................................6
5. Specications...............................................................................8
6. Troubleshooting ...........................................................................9
7. Installation................................................................................... 10
8. Warranty. ..................................................................................... 11

2
Adventure Kings Heads Up Display
INTRODUCTION TO THE HUD
The Adventure Kings HUD (Heads Up Display) contains multiple features that will make your driving
experience easier & in turn safer. The main feature of the HUD is projecting your current speed onto your
windshield. Along with this, the HUD will also indicate your current heading (N.E.S.W.) and has a togglable
option for a speed alarm that will give an audible beep when the chosen speed (default 150 km/h) has been
exceeded.
ADDITIONAL INFORMATION
• The speed displayed by the HUD is for reference only.
• Operation and adjustments to the HUD should not be performed whilst driving.
• Do not use chemical products to clean the HUD, they can cause damage to the unit. A damp cloth
should be sufficient.
• When leaving a vehicle for an extended amount of time, un-plug the device to prevent battery
depletion.
UNIT DISPLAY & SWITCH FUNCTIONS
1. Speed Alarm
2. Setting Icon
3. Driving Directions Icon - West/East/North/South/West
4. Satellite Signal Icon – A red flash indicates the device
is looking for a signal, green indicates the device is
connected to a satellite
5. Speed
6. Light-Sensor
7. Speed unit – Kilometres per hour (KM/H) or Miles per
hour (MPH)
To use the HUD, hold the unit with the switch on the left side, and the display facing up – as shown above.
Display Mode Menu
Short press – Forward - Increase value
Long press – Forward Reset to Factory Settings Rapidly increase value
Short press – In - Select / Next Setting
Long press – In Into Menu Back to Display Mode
Short press – Back - Decrease value
Long press - Back Speed Alarm Toggle Rapidly decrease value

3
Adventure Kings Heads Up Display
MENU OPTIONS
1. SPEED CALIBRATION
2. OVER-SPEED ALARM
3. BRIGHTNESS ADJUSTMENT
4. UNIT OF SPEED
5. AUTOMATIC POWER CUT-OFF
6. DISPLAY MODE
Default: 107
Range: 80 – 120
Description: It is common for car manufacturers to set the displayed speed of a vehicle
below that of the vehicle’s actual speed. In this case the HUD will show
a different speed to that of the vehicle’s odometer. You can calibrate this
through the HUD to prevent discrepancies. If for example your odometer is
showing 5 km/h slower than your HUD, you can adjust the value down from
107 to 102. This will align the two speeds presented to the driver.
Default: 150 km/h OR 150 mph
Range: 10 – 180 km/h OR 10 – 180 mph
Description: An audible beep will sound when the specified speed is exceeded. You can
disable this feature, through the main screen.
Default: 0 – Automatic adjust
Range: 0, 1 – 5
Description: 1 is the faintest and 5 is the brightest.
Default: 0 – km/h
Range: 0 – 1
Description: 0 – Km/h and 1 – MPH
Default: 100
Range: 100 – 150
Description: 100 (10Volts) – 150 (15Volts) when the unit detects the voltage drop below
this amount, the device will turn off.
Default: 0
Range: 0 – 1
Description: 0 the device projects data & 1 allows you to read current speed directly off
the unit.

4
Adventure Kings Heads Up Display
SPECIFICATIONS
HUD Size: 90mm x 52 mm x 13mm
HUD Weight: 40g
Speed Range: 0 – 400 km/h (250Mph)
Satellite Positioning Time: Start-up: 30s / Stand-by: 1s
Compass Precision: ±1°
Working Voltage: 8V – 18V DC
Working Current: 40mA
Stand-by Current: 15mA
12V Car Charger 1A
TROUBLESHOOTING
RESET TO DEFAULT SETTINGS
To revert to default settings, place the HUD with the display facing up and the switch on the left. From
there press and hold the switch forward until all the lights on the unit light up, this indicates that the HUD
has been reset. Then repeat the command to revert to the normal display mode.
HUD IS NOT LIGHTING UP WHEN PLUGGED IN AND THE CAR IS STARTED
Make sure that the device is correctly plugged in and that the cigarette plug is providing power to the
unit. If it is clear there is a solid connection and the unit is still not receiving power, try another outlet in
the vehicle or in another car.
INACCURATE SPEED DISPLAYED
Ensure you are using the correct unit of speed (kilometres or miles).
Press and hold the ‘Push’ function on the switch and navigate to option
1: (single cog) the default value will be 107, adjust this until your speed aligns with
what is displayed on your odometer.
Note: If you have changed the tyre size on your vehicle your odometer could be showing an incorrect
speed.
PROJECTED IMAGE IS HARD TO SEE
If the image is unclear and hard to see try using the reflective film provided. If the reflective film is already
applied; try manually increasing the brightness of the projected image in the menu.
Menu option 3: (cog, W, E) the higher the number, the brighter the display. The default
value is 0 which will automatically adjust brightness based on light levels.

5
Adventure Kings Heads Up Display
CAN’T FIND GPS SIGNAL
The first time the HUD is powered, it will take ~30s for the device to achieve a GPS signal. If the device is
still failing to achieve a GPS signal, try moving to a new area with a clear view of the sky. Along with this,
you can reset the device to factory settings.
INSTALLING THE HUD
Connect the HUD to the cigarette plug using the provided cable.
When the vehicle is turned on the HUD will also turn on. The HUD will then start searching for a GPS
signal, indicated by a flashing satellite symbol .
Position the HUD so that the projected image is easy for the driver to see, then use the included non-slip
mat to hold the HUD in place.
REFLECTIVE FILM
The option to use the protective film is up to the user.
Use of the film will ensure the user has the sharpest projected image possible.
Additionally, it will make the projected image easier to read in varying light conditions and avoid multiple
reflections (ghost images).
INSTALLING THE REFLECTIVE FILM
Installing the reflective film is easy.
First, you will need to clean the area where you will place the film, this can be done using a dry cloth.
Afterwards, take off the adhesive cover and place the film so that the projected image is centred and
clearly visible.
Finally, can use a flat item such as a bank card to remove any air bubbles present under the film.
INSTALLATION

6
Adventure Kings Heads Up Display
WARRANTY PERIOD:
Full 12 month warranty from date of purchase against all manufacturing defects.
WHAT DOES THE WARRANTY COVER?
Under normal usage conditions, this warranty covers:
a. Any defect in design or manufacture which results in the product failing to perform substantially as
described in authorised advertising or literature.
b. We will either repair or replace the product at our discretion providing that the fault is found to have
been caused by a design or manufacturing defect and not misuse or tampering.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure. The benefits provided
to you as the consumer by this warranty are in addition to other rights and remedies available to you
under the law.
THE WARRANTY DOES NOT COVER:
a. Any damage resulting from improper use
b. Faulty installation or modification made during installation
c. The cost of removing and reinstalling the product
d. Travel and /or other expenses due to customer’s remote location
e. Transport charges and damage in transit. It is your responsibility to deliver and pick up your product,
including any costs associated with the postage of your repair or replacement product. If you do
freight your product we recommend that you insure against loss or damage.
f. Any loss directly or indirectly associated with the product failing to operate.
TO MAKE A CLAIM UNDER THIS WARRANTY PLEASE CALL
1800 88 39 64
12 MONTH LIMITED
WARRANTY
OUTDOOR SUPACENTRE PTY LTD
2 Stanley St Silverwater NSW, 2128
PHONE: [phone]
www.4wdsupacentre.com.au

7
Adventure Kings Heads Up Display