AEI Security & Communications CTVM300AFR User manual

Wirefree Monitoring System
CTVM300AFR
AEI Security & Communications Ltd
Pack Contents
1 x Wirefree Camera
1 x Camera PSU
1 x Monitor
1 x Monitor PSU
Fixings & Manual
In the interests of product development,
cosmetic appearance & colour may differ.
1) 13.5VDC Power
2) Mode selector (WIRE/WIRELESS)
3) Audio/Video input (WIRE mode only)
4) Audio/Video output
5) V-Hold picture control
6) Contrast picture control
7) Brightness picture control
1) Power switch (ON/OFF)
2) Volume control
3) Channel selector (1,2,3,4)
4) Audio level meter
1 2 3 1 2 3 4 5,6,7
IMPORTANT NOTICES
This system is NOT SUITABLE FOR
EXTERNAL USE. Exposure to moisture
may damage this device, render it unsafe for
use and invalidate the 1 year warranty.
ALWAYS SWITCH OFF this device prior
to connecting to mains power and when not
in use.
SEE OVERLEAF FOR QUICK SET UP GUIDE
160507-6
4

Quick Set Up Guide
STEP 1
Use the supplied fixing kit to mount the
camera bracket to a wall. Slot the the
camera on to the bracket and tighten
screw to hold
STEP 2
Connect the 7.5VDC PSU to the
camera and a suitable mains outlet.
USE ONLY THE PSU LABELLED ‘CAMERA’
STEP 3
Select the desired operating channel
if required. Where multiple cameras
are used, you will need to select a
different channel for each camera.
Tighten to lock position
1) IR Night Vision LED’s
2) Microphone
3) Focus Adjustment
4) Channel Selector
5) Antenna
6) 7.5VDC
1
2
4
5
6
3

STEP 5
Position the monitor in a suitable
location on a flat stable surface.
STEP 6
Connect the monitor PSU to the
monitor and ensure the mode
switch is set to ‘WIRELESS’
STEP 7
Connect the monitor 13.5V PSU
to a mains socket and switch ON
STEP 8
Switch ON and press the channel
1 selector.
WARNING
The supplied power supplies may get hot during extended
periods of use. This is normal and is NOT a hazard.
DO NOT COVER the power supply units.

PICTURE QUALITY NOTICE:
If you experience picture quality issues with this system please try the
following. In the event the problem cannot be solved, please contact the
AEI Helpline on 0845 1667940 or visit http://www.aei.eu
SYMPTOM SOLUTION
Rolling/Unsteady Picture Adjust the V-HOLD control on the rear of the monitor
Too Bright/Dark Adjust the BRIGHTNESS control on the rear of the monitor
Unclear/’Grey’ Picture Adjust the CONTRAST control on the rear of the monitor
Interference Change the channel setting on both the camera and monitor
Fuzzy/Out of focus Adjust the focus control by turning the lens on the camera
Hereby, AEI Security & Communications Ltd., declares that this
wireless A/V device is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Waste electrical products should not be disposed of
with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice
A/V Channel 4 not licensed for use in the following
countries: F(France), E(España)
0197
©2007 AEI Security & Communications Ltd. All rights reserved.