Aeromax 40 Easy Stik ARF User manual

Assembly Instructions
Wing Span 1470mm
Wing Area 36 sq.dm
Length 1050mm
Weight 2200g
Engine .40~.52 2S
Before Beginning assembly, please read these
instructions thoroughly.
Radio -Controlle d AircraftRadio -Controlle d Aircraft
This radio control model is not a toy!
40 Easy Stik ARF 40 ARF

Parts of the airplane
Accessories

1.Main Wing
1
4
The main wing has slight dihedral.
Ensure that the two wing halves are
securely glued together with epoxy.
确保 粘 牢
在此 处 钻孔， 方 便胶水 流 入
Create small opening here
to allow glue to seep through.
2.Aileron Servo

2
用笔 在 这里做 个 记号
Measure the position of
the wire that aligns with
your servo arm.You will
bend the wire at this
position.
2.Aileron Servo
用胶 带 加固
You may use tape to further secure
the clevis.
The clevis needs to be
secured onto the pushrod
for about 8mm (3/8 in)
拧进去8mm左 右
Bend the end of the wire into a right
angle.Depending on the length of
the wire needed, excess wire can be
removed
弯成9 0度并剪去多余的钢丝
Servo Setup
Servo and screws needs to
be purchased separately.
2mmX15mm
2
Screw

3.Stabilizer &Elevator
将平 尾 粘到机 身 上.
You should make sure both the rudder
and the elevator are properly centered
with the fuselage.
3
Glue the horizontal stabilizer to
the fuselage

4
3mmX18mm
4.Main Landing Gear
3
5. Nose landing gear
Screw
尾撬

5
degrees by the user
The wire needs to be bent 90
照前 面 的方法 安 装方向 舵 机
Using the same procedure as previously,
to install this servo and pushrod.
6.Stabilizer &
Elevator Servo
2mmX18mm
2
Screw

6
7.Engine
3
4mmX30mm Screw
3mmX30mm
Screw
8.Throttle Servo
Engine needs to be purchased
separately.
发动 机 另购

9.Fuel Tank
AIR
To Engine
Pumpi ng fuel
7
10. Fuselage Setup
11. Main Wing
Wing Setting
接收 机 和电池另 购
Receiver and battery need to be
purchased separately.

Suggested C.G.
75mm
The suggested C.G. is only
a starting point for your
setup process. You should
reposition the receiver and
battery until you achieved
the desired balance.