T3 Simulations Hemmet User manual

HEMMET Photo Instructions

HEMMET instructions:
These are resin and metal bit kits. They require some cleaning before
assembly
•Remove pieces from the sprues and clean all pieces
•You will need super glue to assemble these kits

Main HEMMET assembly
Parts for main HEMMET body After cleaning
glue on
wheels.
Add smoke
stack to
engine
block Add transmission
and attach to main
body and
undercarriage box
Glue on mirrors to
cab and then attach
cab to main body
assembly
You can have
only the hatch,
or full .50 cal
coupla.
Base HEMMET assembly
Attach upright to
back of engine
assembly

Flatbed and Gun Truck Version
Flatbed and Gun Truck share many of the same
pieces and assembly is the same for both.
Parts for
Flatbed/Gun
truck.
Attach flaps to under
carriage of flatbed/gun
truck.
Attach control
box to base of
crane
Attach supports to base of
crane
From the bottom, attach
base of crane to back of
flat bed. There is a slot
for the crane base.
Attach flaps as shown.
Then glue to base model
undercarriage from
previous steps
Attach crane to
base.
Finished flat bed should
look like this

Finished Gun Truck should look like this
Use flatbed instructions for
bed assembly
Add .50 cal
support poles
and guns

HEMMET Fueler version
Parts for Fuel
truck.
Attach flaps
Attach box behind engine
compartment
Attach fuel back to main truck Finished Fuel Truck should look like this

HEMMET Wrecker
Wrecker parts and base
HEMMET
Attach work area to base HEMMET Attach flaps
to rear bed
Attach
control box
to rear bed
Attach jacks Attach jacks to
base HEMMET
Attach rear deck to
base HEMMET
Attach crane
to rear deck Attach Tow bar
support

Attach safety
lights to rear deck
and tow bar
support Attach tow bar assembly
Finished Wrecker should look like this