Ag Leader Technology GPS 3000 User instructions

2202 South Riverside Drive, P.O. Box 2348, Ames, IA 50010
Phone: [phone] Fax: [phone] Internet: http://www.agleader.com
7/12/2007
WAAS Changes
GPS 3000 / 3050 / 3100 / 4050 / 4100 / 5100
Setting up the receiver with Ag Remote
Version 3.00 firmware is required to enable WAAS satellites 135 and 138
Connect your receiver to a PC and access it with Ag Remote. Refer to www.agleader.com if you do
not have a current version of Ag Remote.
1.View the receiver firmware version. (Press Status / Receiver Status / Version.) If you do not have version
3.00 installed, use the FlashLoader 100 utility to update the firmware. You can download the firmware
and the FlashLoader utility from www.agleader.com
2.From the receiver Home screen, press ⇒two or three times, depending the receiver model, to access the
Configuration menu. Press ⇓to enter Configuration and then press ⇒to access the DGPS Config
menu.
3. From the DGPS Config menu, press ⇓four or five times to access the SBAS Sats screen. The satellite
name and status appear on the lower line.
4. Press ⇒. The cursor blinks on the satellite name.

2202 South Riverside Drive, P.O. Box 2348, Ames, IA 50010
Phone: [phone] Fax: [phone] Internet: http://www.agleader.com
7/12/2007
5. Press ⇓to scroll through the list of satellites until you reach 135. The status value is Disabled.
6. To edit the satellite status, press ⇒and then press ⇓to change the value to Heed Health.
*Note – Repeat steps 6 and 7 for satellite 138 if needed.
7. To save these settings, press Enter. The screen resets and shows AOR-E Disabled.
This is normal.
8. Disable the AOR-W satellite. Press ⇒. When the cursor blinks on the satellite name,
press ⇓one or more times until AOR-W appears.
9. To edit the satellite status, press ⇒and then press ⇓to change the value to
Disabled.
*Note – repeat steps 8 and 9 to disable satellite POR
10. To confirm that your settings are saved, repeat step 3 through step 5 and then
press Enter when finished.