Ag Leader 6500 Reference guide

MD5005
rev 6
DigiFarm Technical Support
319.531.7574
[e-mail]
DigiFarm
Quick Reference Card
Ag Leader 6500, 7500 & RV50
Ag Leader 6500 & 7500 Display Setup
1 Connect the RV50 and the adapter to the Port B
connection on the Ag Leader 6500/7500 cabling
Note: The null modem cable is needed for all modems
2 Connect the Power Tee to the Can B power/
terminator connection on the Display cable
3 Tap the Setup wrench icon, then the icon
4 From the GPS/Guidance setup screen, select the
wrench icon next to “Autodetect”
5 Ensure the Di󱐱erential source is set to “RTK external”

MD5005
rev 6
DigiFarm Technical Support
319.531.7574
[e-mail]
DigiFarm
Quick Reference Card
Ag Leader 6500, 7500 & RV50
*Note- If this unit was ordered with a subscription, it will be preprogrammed and plug and play ready.
The following instructions will not be needed.
Log into the device via WAN static IP (166.XXX.XXX.XXX:8080) or LAN connection (192.168.1.1:8080) on Port
8080.
Username: digifarm
Password: digifarm
You will then be directed to the page shown below. On this page you can select a receiver preset based on
the receiver type you have, then enter your username and password. Save device info at the bottom then
select the reboot icon at the top of the screen.