AG Neovo FMC-06 User manual

Installation Manual
100.0 kg
(220.4 lb)
FMC-06

M8×25
M6×130
14pcs
1pc
1pcs
4pcs
1
2
Other accessories (in mm):
Adjustable wrench (self-provided)
Phillips screwdriver (self-provided)
M6 screw (on wall hanging strip)
M12 spring pad
3
Cross recessed pocket hex head screw (including positioning pre-lock bolt)
1
Bill of materials:
A- Left leg 1pcs
B- Right leg 1pcs D- Tray 1pcs
C- Wall bracket 1pcs
E- Castors 4pcs
F- Wall hanging strip 2pcs
FMC-06 Installation manual
1
To ensure using the stand correctly and safely, please read this manual carefully before installation.
This model is recommended to be used for 55-86 inch interactive flat panel.
Maximum load capacity: 100KG.

22
2
2
A
B
E
Figure 1
Step 1 : Adjust the wheel to the brake state and screw it into the leg ( Figure 1).
When turning the wheel,
adjust the wheel to the
brake state in advance

3
1
C
1
2
3
4
5
6
55"
65"- 70"
75"- 86"
Figure 2
Positive
Positive
Bracket hole
Step 2: Attach the wall bracket to the end leg (Figure 2).
Wall bracket hole position suggestion
Monitor size Matching hole position
3rd and 6th holes
2nd, 5th hole
1st and 4th hole

4
1
D
1
Figure 4
Tighten all bolts
Insert the tray into the
positioning bolt on the
column firstly
Snap the tray into the
positioning bolt
Step 4: Assemble the tray between the two columns (Figure4).
Figure 3
Step 3: Attach the other leg on the other end of the wall bracket (Figure 3).

5
Step 6: The assembled machine will be hung on the wall bracket and the safety
screw of the wall hanging strip will be locked ( Figure 6).
Make sure the brakes are locked. This step requires at least 2
professionals to complete.
Figure 5
Figure 6
Step 5 : According to the actual requirements of the whole machine,
lock the wall hanging strip on the whole machine (Figure 5).

6
1
2. Hang the machine on the wall hanging and lock the safety bolts
Positive
Positive
Make sure that the
side of the wall
hanging board with
the locking hole
is front
1. Lock the wall hanging board to
the wall bracket
Remarks: In some cases, the machine's wall mount bracket don't match with wall mount of
the stand, and need to be adjusted with the wall mount together.
Following is the adjusting process:

7
Step 7: After the assembly is completed, refer to the figure below.
FMC-06_User Manual_V011