Agilent Technologies E5071C ENA Series Quick start guide

I
I
IN
N
NF
F
FO
O
OR
R
RM
M
MA
A
AT
T
TI
I
IO
O
ON
N
N
O
O
ON
N
NL
L
LY
Y
Y
ADMINISTRATIVE INFORMATION
SERVICE NOTE CLASSIFICATION:
INFORMATION ONLY
AUTHOR: jm PRODUCT LINE: WN
ADDITIONAL INFORMATION:
© AGILENT TECHNOLOGIES, INC. 2007
PRINTED IN U.S.A.
June 6, 2007
Page 1 of 2
E5071C-01
S E R V I C E N O T E
Supersedes:
None
E5071C ENA Series Network Analyzer, 9 kHz to 8.5 GHz
Serial Numbers: MY46100001 and above
When replacing Inverter Board and LCD, fasten the TORX T15 screws using a
torque screwdriver (set to 1.02 N-m / 9.0 lb-in).
Parts Required: see solution

Page 2 of 2 E5071C-01
Situation:
When replacing the Inverter Board and LCD, no torque info is shown in the service guide.
If you fasten the screw with over the appropriate torque, A51 LCD might be damaged, and if you
fasten the screw with under the appropriate torque, LCD module might not be fixed against the
vibration.
Solution/Action:
When replacing Inverter Board, fasten the TORX T15 screws (item 2) using a torque screwdriver (set to 1.02 N-
m / 9.0 lb-in).
When replacing LCD, fasten the TORX T15 screws (item 5) using a torque screwdriver (set to 1.02 N-m / 9.0 lb-
in).
- End of Document -